How to hide the wire from the TV on the wall: interesting ideas and recommendations

If you purchased a new TV, this could cause a lot of wires. You can hide them in the wall quite simply. There are several options for this. But before that you need to make sure that several rules are followed. For example, electrical wires should not have insulation damage. In addition, during operation, they should not get condensation and moisture.

In order to exclude "stray" pickups on the TV signal, the wires should be placed as far as possible from the power lines and equipment of the type:

• Microwave ovens;
• Refrigerators;
• Washing machines;
• Irons.

This includes other devices that require the use of large starting currents during operation. If you are thinking about how to hide the wire from the TV on the wall, you should remember that you can place the cables in a special channel with low-current lines, among them:

• phone line;
• the Internet;
• signaling.

Recommendations of a specialist

It is important to remember that television wiring should be performed in whole pieces. Crossing of the cable and power lines of the mains can not be tolerated. If this can not be avoided, it is important to ensure a right angle intersection.

When performing installation work, you should use the splitters and splitters of the factory-built TV signal, because only they will be able to provide reliable wire contact and shielding of the input signal. Before you hide the wire from the TV on the wall, you must remember that the twists of the wires should not be used. They are not able to provide good shielding, which will certainly affect the signal quality.

How to avoid mistakes

When laying wires, you must exclude loops, sharp bends and twists in the bay. The soldered connections of the wires should be used in the shield box, while the unshielded sections should have a minimum length, only so you exclude a decrease in the quality of the signal reproduction. The splitters and cables should be located in places where they can easily be serviced. Here it is possible to carry junction boxes.

If you are faced with the question of how to hide the wire from the TV on the wall, you should know that it can be located along with the power lines. In this case, the diameter of the central wire should be more than one millimeter. It is better to use a material with a double screening or a pair of layers of foil under and above the braid.

Wire laying in a box

The simplest solution for concealing the cable will be the use of a cable duct or decorative box. Such products are usually made of:

• Metal;
• Plastic;
• Combined materials.

Such a decision has the right to exist because it meets the fire safety standards, has an aesthetic appearance and is easy to install. However, this version of cable laying has its drawbacks, they are expressed in high cost for products and lack of recommendations from the manufacturer.

Before choosing a box, you need to determine its size, as well as decide which cables will be hidden in it. If you are faced with the question of how to hide the wire from the TV on the wall, then you must remember that when laying wires in the cable channels inside there should be free space. It can come in handy in the future.

Do not hurry with the acquisition of the cable channel, because you need to pay attention to the transitions for the corners, butt elements, plugs, tees and other fittings. It will be able to give the appearance of the box aesthetic appearance. In addition, the master will not encounter any difficulties with the installation. When choosing the described products, it is important to consider their quality. Experts advise paying attention to the castle. It should open and close manually, you do not need to use additional tools.

Cable laying in the wall

The most aesthetic and reliable way to hide the cable will be the solution, when the wires fit into the thickness of the wall. For this, voids are prepared between the drywall sheets and the wall itself. This method is most common, but sometimes it takes a lot of time to implement it, and in some cases it takes a lot of money for this technology. If you installed the TV on the wall, how to hide the wires, you will certainly ask yourself a question.

In order to hide the cable in a concrete wall, you can use the method of shtrobleniya. The process will be quite dusty, but it is suitable only for those who repair and parallel the cable. In this case it is necessary to decide which wires should be hidden, where they should appear from the wall, and also where the sockets will be located.

Shtroby should be laid strictly horizontally or vertically, so you were sure where the wire passes. After all, sometimes after repairs there is a need to hang furniture or a picture. In this case, it will be important not to get on the wire while drilling holes.

Decoration of wires behind drywall sheets

If you have to hang the TV on the wall, how you can hide the wires, you should think before you start work. To carry out manipulations for the decoration of wires in gipsokartonnyh sheets should be prepared:

• Cutting knife for gypsum plaster;
• Wire;
• Rope or strong thread;
• Nut;
• Insulating tape.

Operating procedure

On the wall in the first stage, brackets are installed to fix the TV. The angles of its location should be marked with an insulating tape, in the course of work this will allow not to go beyond the zone that will be hidden. Now the master has to note where the socket for connecting the device will be located. On the surface of the drywall, markings can be made for future holes. The installation area of the socket must be marked to within a millimeter, this will allow it to be installed without the formation of voids.

To lay cables in the wall, make cable channels. In the lower part of the wall another hole is made, through which the wire will be hidden in the plinth with the cable channel. The socket can be installed behind the TV, but this is only relevant if it is removed from the surface or installed on a movable bracket. In this case, the outlet will be easily accessible.

How to hide the wire from the computer

If you want to make the premises of your home more attractive, you need to know how to hide the wires from the TV, computer. In the latter case, the cords can be disguised under the table top. At the same time, they are strengthened with the help of clips mounted on self-tapping screws. If you plan to move the table in the future, you can use double-sided scotch for this. When the table does not want to spoil, you can use a box from under the shoes, after having originally decorated it for the interior of the room.

If you are wondering how to hide the wires in the apartment, we mask the wire with a special cover that you can make yourself. It is perfect for an extension cord, which will plug in all the plugs. If you are constantly disturbed by the cord from the speakers, then it can be hidden in the appropriate cover, which is pre-fixed to the back of the table.

Conclusion

Today, TV is often installed on the wall. How to hide wires in an interior, many owners of apartments and houses reflect. As one of the most reliable and aesthetic solutions stitching holes will perform. An angle grinder can be used for this. It is only necessary to deepen the surface by 1 cm. Tile glue is applied to the resulting slit, after which the wire is laid in the mixture and masked with a trowel.

If the wall is made of plasterboard or simply covered with a trim made of this material, it will be necessary to make a rod from a thick aluminum wire. It will serve as a broach, because with his help you can stretch the cable or wire behind the plasterboard on the wall. Many are wondering not only about where to hide the wires from the TV on the wall, but also about where to lay communications on the ceiling. The above procedure is suitable for a suspended system, which is most often performed just from plasterboard.