Well at the cottage. We will dig the source of water supply with our own hands!

Without the source of pure water, all the charms of owning your own country house are reduced to zero. You can not water your lawn and do not fill the children's pool. Yes there! Even cooking will turn into that other problem.

If you do not want to buy precious liquid in bottles, the well at the dacha will help you . It's quite real to dig it out with your own hands, and it will take relatively little time. For the cheapest option you will only need a screw, which can be made from a steel pipe.

How to prepare a pipe

Naturally, simply because you can not drill a hole. To do this, you will have to make some improvements in the design associated with the use of an ordinary fishing drill. But also on its cutting edges it is necessary to weld reinforced cutting edges, since otherwise it will not be possible to take it far to the ground.

It is best to use steel from files for this purpose. In addition, you need to get a wheelbarrow to transport the excavated soil, shovels and a pump with a sufficiently long hose.

Before you dig a well into the dacha with your own hands, let us once again turn to the topic of fine-tuning the pipe. Leaving from its lower edge to a meter in height, drill a few holes (diameter of 6 mm) for two meters. This is done to ensure that its internal diameter is not clogged during operation.

Getting Started

The place where you are going to conduct drilling work, you need to carefully clean from debris and level. After that, dig a small depression (two or three bayonet bayonets) for better direction of the drill, after which you can start to work.

To enjoy all the advantages that the well gives to the dacha, you will have to work a lot with your own hands. To make the drill easier to enter the ground, at equal intervals it must be extracted and shaken off the adhered soil. From time to time the work place is watered with water, which facilitates the passage of dense layers of earth.

As soon as the handle of your tool approaches the ground, it needs to be increased. After that, working with him may not be very convenient, you can stand on the table or something like that.

Up to what time to dig?

Your well at the dacha, with their own hands to do which everyone can, will be almost ready when you reach the aquifer. It is easy to understand this, since the extracted soil will be wet.

After that, you can get a pre-prepared pipe. To prevent it from clogging, when lowering into the well, you need to insert it several times and get the tool back. So you will break the possible plugs from the ground, which can clog your water pipe.

Prorolling

As we have already said, drilling a well at a dacha provides for the presence of a pump. It must be lowered into the well and pumped out of water, removing dirt from the aquifer. Since the process of swinging is quite long, we recommend immediately taking care of the presence of a long drain hose, through which dirty water will be diverted away from the site of excavations.

We described the process of manual drilling. But if you need to drill an artesian well at the dacha, you will have to use the services of specialists, since you simply will not get hold of the hand tool to aquifers.