Replacement of pipes in an apartment is a forced necessity or a planned undertaking?

When the pipes are replaced in the apartment, the first thing to do is to cut off the water supply - both hot and cold.

Replacement sewer pipes in the apartment involves a complex and time-consuming process of removing the old riser. For this, the Bulgarian cuts are made: the bottom cuts at a distance of 60 cm from the top of the tee, the upper one - from the ceiling at a distance of 10 cm. The incisions are made in the pipe at half its diameter. After in these places several strokes are applied with a hammer and a chisel, a heavy cast iron industrial product should burst and then it needs to be removed.

At the next stage of work, it is necessary to remove the tee from the socket, then clean it of debris and dirt. When the riser is dismantled, the remaining components of the system are removed, if necessary, a Bulgarian is used.

Further, the replacement of pipes in the apartment after the removal of old ones continues with the installation of new ones. Nowadays, plastic sewage industrial products have gained popularity. To mount the system, a cross is installed from this material, a rubber cuff (pre- lubricated with silicone sealant) is inserted into the funnel-shaped extension from below, in which the tee is then fixed and a pipe of the required size is inserted into it. The rack is fixed to the wall with specially designed clamps, it is assembled completely and the system is checked for leaks.

After such an assembly, the replacement of the sewer pipes in the apartment continues with the internal wiring of the system. For it, it is necessary to use industrial products of suitable diameter, of high quality, undamaged and non-worn. All funnel-like expansions should be installed to meet the water current, and the pipes - with a slope per meter 20-25 mm. In general, this process has nuances, at first glance invisible. Replacement of pipes in an apartment is made only in the direction from below upwards and not otherwise. With a responsible approach, the completion of the process will be successful.

Replacement of water pipes in the apartment must begin with calculations. If communications are not transferred, it is sufficient to measure the product footage and compile a list of wiring materials. To do this, you need to count all tees, corners, valves, writing down the quantity, so as not to forget to buy a single detail.

If the riser has a shut-off valve, then this is the starting point of the work, in case of its absence, you need to include it in the list. Once the valve is in place, a coarse filter, a counter and a check valve are installed . Only after such an assembly you can put a tee, from it and will be wiring.

Replacement of water pipes in the apartment has its own nuances. When buying plastic products, it is desirable to choose seamless, they will last much longer. Its peculiarity is the replacement of pipes in the apartment, connected by soldering. The permissibility of leakage through such joints is completely excluded. But if the area of these pipes is damaged, a replacement of them is inevitable. Metal-plastic in this case can be reanimated by unscrewing the union nuts and replacing the damaged component with a new one without any special problems.