HobbyNeedlework

How to make petards with their own hands

In each of us, at times a little rogue wakes up, who wants to blow something up. For such purposes, firecrackers are best suited. Most people buy them, but it turns out that it's quite easy to make them yourself. How to make a firecracker? It turns out that it is very simple and affordable for any person.

Necessary materials
For our purposes we will need:

  1. Pliers.
  2. Blunt nail.
  3. Wire.
  4. Paper.
  5. Telescopic antenna.
  6. Eraser.

First step

Before you make a firecracker, you need to prepare all of the above materials. If this is done, it turns out that the self-made manufacture of firecrackers is not such a difficult task. First, you need to break off from the telescopic antenna a small piece - about 3-6 centimeters. After this simple procedure, it is necessary to bend the antenna twice, and on the reverse side you need to wrap it up so that you can put something in the resulting tube.

Second step
After completing all the procedures specified in the first step, it is necessary to perform a number of operations in order to make a firecrack by yourself. It is necessary to cut off a fairly small piece from the eraser (gum) taken with scissors. After this, it is necessary to insert this piece into the tube, always to the very end, which was bent.

Third step

The basis for the firecracker is done. Now you need to get the pliers and crush the head of the match from the sulfur, collecting the powder on paper. So you need to scrape off all the sulfur heads from the box, because for the firecrackers need a lot of sulfur. Then it is necessary to crush the resulting mass - and the filling for the firecracker is ready. As you can see, indeed, the answer to the question of how to make a firecracker will be as follows: "It's easy!".

The fourth step

Next, you need to bend the piece of paper with sulfur in half and fill the tube with the resulting sulfur powder. Next, some advise to take a fairly thick wire and "bite" it with cutting pliers first vertically, and then horizontally at a small distance from each "bite". As a result, an additional charge of tiny iron pieces will be obtained, which must be filled up with sulfur in the tube. However, this advice can hardly be called reasonable, because when launching such a firecracker on New Year's holidays or on another solemn day, you can not only seriously injure yourself, but also endanger the surrounding. Therefore, it is better to skip this step.

Fifth step

With the help of the previously taken stupid nail, it is necessary to shorten the charge of the firecracker (either just sulfur or sulfur with iron impregnations). Just put the nail and start ramming. The main thing is to do it well, otherwise the explosion from the firecracker will be weak, without quite loud and expected sound effects. If it is good to compact, then you can blow up the firecracker even without sealing the "package". After ramming the sulfur, you need to cut off the piece of eraser again and close the tube in the same way as on the previous side, as we did at the beginning of the conversation about how to make a firecracker.

Last step

It is necessary to wrap the firecracker in a bag that will remain on fire. Do not forget to move to a safe distance so as not to damage your health!

Similar articles

 

 

 

 

Trending Now

 

 

 

 

Newest

Copyright © 2018 en.unansea.com. Theme powered by WordPress.