How does the roof of the house look like with their own hands.

To date, installing a roof on a house is not such a difficult undertaking. The roof of the house with their own hands is a less expensive type of work, but without the help of a small team of people, work can take a long time. The roof for the house is one of the most important components, since without it no master will feel completely safe before the climate tests. That is why many owners think correctly how to build the roof of the house. In this article, it is planned to highlight the general principle of work on the production of a saddle roof.

In order to ensure that the roof of the house with its own hands was durable and meet all the safety rules, it is necessary to first design its frame on paper, and only then start the installation. For the construction of the roof, we will need to buy a bar with the standard dimensions of 50x150x6 in the required quantity. This bar is calculated based on the fact that the placement of these bars will occur on the roof every 60 cm.
Since our roof will be single-skinned, then on one of the supporting walls of the house it is necessary to install vertical standing sections from the bar for installing directly the bearing beams. Each of these vertical segments must be fixed to the wall using self-tapping screws, approximate length of each of 9cm. Before installing and securing the beams, you must first check the vertical level and drill the holes in the vertical racks at an angle. The height of vertical racks is calculated based on the projected angle of the roof slope of the house.

The hardest thing is that the roof of the house with their own hands was installed correctly is the process of raising the 6-meter-high bars on the wall of the house. For this job, you will need a team of 3-5 people, because one is simply not physically able to do it. One of the ends of the 6-meter beam should be fixed to a vertical support, reinforced with the help of self-tapping screws. The second end is best placed in the cutout in the wall at a distance of 5 cm deep. After that, this end is also fastened with screws.
One of the most important moments is the problem with the horizontal laying of single-bearing beams, which will give the ceiling a perfectly even execution. This problem is solved with the help of a universal building level and a 5-meter rope. The process of horizontal laying of the beams is as follows:

1) To begin with, a single-faced beam with one end must rest on the wall, and the second end, previously tied with a rope, is attached to the already installed beam. Then, on the beam to be installed from above, we must put the level.
2) By attenuating the rope gradually we reach the position where the beam begins to assume an absolutely horizontal position. After leveling the beam, we tighten it into a knot on the rope.
3) Attach the beam to the beam. To do this, it is best to choose the following connection method: fasten the beams by fastening the two bars through and through the places where they are fastened together. For fastening it is best to use studs with a diameter of up to 10 mm, as well as washers and nuts, which are connected together.

After the roof of the house with his own hands is almost finished, it is necessary to tackle the fencing of the pediment. This small space between the wall and the roof is best clogged with boards with a thickness of 20 mm, and can be fastened to vertical racks with nails or bolts with nuts.
Thus, all the work on the correct installation of the roof and roofing will take no more than 3-4 days. I hope that after this article the question of how to make the roof of the house, you no longer worry. If there are any questions, please contact the personal mail on the site.