A harness for dogs with their own hands: patterns, sizes, types. How to make your own hands a harness for a dog?

Undoubtedly, walks on a harness for an animal are more comfortable than on a leash with a collar. Because it does not press on the neck and allows you to breathe freely, and the owner is easier to control his pet.

For military dogs use the same harness, but more solid and complex design. But in spite of the fact that in our time there is a large selection of ammunition for dogs, if you want, you can put some effort and time to get an exclusive harness for dogs, made with your own hands.

Materials for the production of canine ammunition

Today, such accessories can be bought absolutely for any dog: be it a Pomeranian Pomeranian or a Doberman. Sew a dog's harness basically:

- from braid or ortalion;

- nylon;

- Tarpaulins;

- Velor;

- leatherette and other materials, including natural cotton fabrics.

How to choose a harness for a dog, each store seller will tell, but not always there are means for its purchase, or among the assortment there is no suitable. Fortunately, you can sew the usual walking harness yourself. This is not difficult at all, and the model in this case will definitely suit the owner of the dog.

The main thing is that the product should sit correctly on the pet: it should not press, but only snug tightly to the body.

For dogs of medium and large breeds, harnesses are needed during training or when doing sports: for towing a skier, different dog competitions (running in a harness) or just for developing muscles, etc. The harness for dogs with their own hands is made of strong enough materials with a strong buckle and carabiner: leather, thick belt or braid. However, the accessory should not be too heavy to make the dog comfortable.

Also, do not put on a harness constantly, because the pet has a different center of gravity during movement than from the movement in the collar, and after training with the dog it becomes more difficult to get used to something else, and if necessary temporarily to walk without a harness Four-legged friend can not feel comfortable.

Nylon Straps

They are much lighter than leather or leatherette. And they are the most durable and durable, not inferior to products made from other materials. To sew a comfortable enough thing for your pet, first of all it is necessary to decide what you need:

- for towing;

- for the harness (a nylon model without buckles and rings, as well as buckles and a fastening rope is appropriate here).

Leather harnesses

To deal with a service dog, it is better to sew a product made of leather with strong and wide buckles and belts. Only make sure that the rings are well welded, and the straps are properly sewn to get a strong harness for the dog. Pattern is suitable for anyone, like it.

And you can make a combined model: leather and nylon, so it will be easier and cheaper. Buckles and rings when shopping also do not hesitate to check for quality.

For the smallest dogs

For decorative dogs the harness has already become a mandatory accessory. For example, four-footed with thick necks, such as pugs, French bulldogs and other things, it is much more convenient to walk on a harness. And miniature fragile representatives of dogs with a gentle neck and thin neck (Yorkshire terrier, chihuahua, etc.) is also better to offer soft velories than collars.

And you can decorate a finished product than your heart desires: crystals, crystals or thorns, if only the scenery does not harm the animal.

Rules of independent tailoring

How to make a harness for the dog yourself? The most important point - it should ideally fit in size. In addition, the product must be designed for the physical strength and temperament of a four-legged friend, and the breed also matters. You should choose a type of harness and, depending on what it is for: for ordinary walks or sports, for a guide dog or helping in search and rescue activities.

On what before sewing it is necessary to focus attention:

- You can choose any material that you like, but it must be both soft and wear-resistant, and strong, and even easy to wear off.

- It is better to equip a harness not with one clasp, but several at the same time. This is necessary in order for the dog not to feel discomfort during the procedure of putting on an accessory. Therefore, from the model in which it will have to be "squeezed in", it is better to immediately refuse.

- Recall that a harness with a tight fitting to the body of the dog is the best, but it should not be squeezed or constricted in any way. And to check whether the size of the product is correctly chosen: it is only necessary to put a palm between the trunk and the animal, and if it enters safely, it means that everything is in order. Also, if the harness is too loose and sagging, you need to adjust it to avoid injury.

- It should be ensured that the belts in the upper part of the product converge with the width of the dog's back, would not be narrowed, or they may crash into the body, and such a harness for the dog will cause pain. Pattern must match the parameters.

- At home you need to remove the harness, and on the street there is no point in constantly wearing it.

- It is important to combine a harness with a collar, especially dogs that regularly attend exhibitions. Otherwise in the ring your friend will experience discomfort in the collar, because the harness will have to be removed there.

How to properly measure with a dog

To ideally remove the measurements from the dog, you will need a tailor's meter. Observe the measurement rules.

- The defining measure is the length of the back from the place where the withers begin, to the place where the base of the tail is.

- The neck should be wrapped around the collar.

- The chest circumference should be measured at the widest point, behind the front paws, adding 2 cm to the resulting figure for a free fit.

Sewing Instructions

A harness for dogs, made by hand, does not require a lot of expenses, you will only need:

1. The material you selected.
2. Material on the lining.
3. Soft braid.
4. Rings for fasteners.

Determine about the material for sewing the harness (for a harness for large dogs you need to use a more durable material), whether it's leather, nylon, imitation leather or something else.

1. Measuring your dog the way it was previously indicated (under the paws in the chest area) we build a pattern with allowance for seams. If it's nylon - add 2 cm to the seams, if the imitation leather or leather - about 5 mm on the seams.

2. For this pattern, we make a lining of soft material and we spread it along the inner side of the future harness.

3. We cut out the whole product and sew the soft tape along the entire perimeter. From the outside we put straps on, and in the back zone we attach fastening rings. You can also make straps with rings to adjust the length, if the dog continues to grow.

4. Think about the finish on your own. Designed for decorative miniature dogs, harnesses are often trimmed with multi-colored rhinestones, stones, fabric stickers, bows, etc.

If the sewing of the harness did not take place, do not get discouraged, from the first time it's not enough for anyone who does it perfectly. You can remake the product or sew again, and if the lesson seems too difficult, you can order it in the workshop.

Weighting agents for loops

A harness with goods for dogs is only needed for large and strong animals, for example fighting or service animals. The accessory is recommended in case of an acute shortage of the loads put to the breed to restore the lack of muscle mass. Such a thing ideally trains endurance in medium and large animals.

However, a harness for dogs with weighting agents for animals is not sewn under the age of one year, because the backbone of them is still in the process of formation. Otherwise, you can seriously harm the dog, and not get a benefit.

In general, for some breeds, strong power loads are very useful: pit bulls and staffers, pit bull terriers and rottweilers, sheep dogs, etc. For such powerful animals, and invented different ways of strength training. It is proved by veterinarians and researchers that a harness with weighting is simply necessary for dogs that are deprived for some reason of physical exertion. And this kind of accessory with a load, dragged by dogs after themselves, should be used by the owners who wish to see their dog healthy and strong. Walking and training with a cargo harness help to quickly gain weight, correct the deflections of the back and strengthen the hock joint.

When it is possible to apply ammunition with weighting agents

The time when it is possible to put on a harness with weighting depends primarily on the breed of the pet and the nature of the training. One cargo is advised from year to year, another - from one and a half, the third - not earlier than two years. Therefore, before buying this harness and starting to use it, it is necessary for the owner to consult an experienced trainer or at least with a veterinarian, and then clearly follow all recommendations received.

And most importantly, a harness for dogs with their own hands with a load should be made by knowledgeable people, in fact, a lot of nuances should be taken into account, and if you miss something, do not take it into account, then from one wrong step the health of your pet will suffer. It is necessary to manage the weight of the cargo very carefully and competently. A harness for dogs requires an exceptionally tailored tailoring, just under your dog, to avoid big problems in the future. From self-tailoring such a thing with a little experience is better to give up.