Homeliness, Bath or shower
Why the tap is buzzing: causes
Problems with the work of plumbing in the house arise quite often. The most common phenomenon that causes discomfort in residents is the appearance of unpleasant sounds in the system. Let's look at why the water pipes are buzzing when the crane is turned on.
Poor installation of system components
Close arrangement of pipes
Why are the pipes hummed when you open the tap? Often such a phenomenon is observed in cases when the elements of the water pipe are in direct contact with each other. To solve the problem, it is necessary to find closely located pipes. If it is impossible or difficult to change their configuration, it is enough to wrap each water conducting element with special polyvinylchloride insulating casings that can be purchased at any sanitary ware shop.
Excessive system pressure
Excessive pressure level in the water supply system can eventually lead to the depressurization of certain structural elements and the flooding of housing. To reduce the load on the pipes and remove annoying sounds, it is recommended to resort to installing a special pneumatic camera. The latter is mounted at the junction of the mixer with the pipe and assumes overpressure.
Finally, to verify the presence of just such a cause of the buzzing and buzzing in the system will allow the call of plumbing, which will determine the level of pressure in the water supply system. Normally the indicator should be equal to 2 atmospheres. In this case, the mixers, dishwasher and washing machine will not be subjected to destructive effects. If the pressure in the system is 6 atmospheres or more, this is the reason for handling the complaint to the service provider.
Clogging of pipes
The decrease in the internal diameter of the pipes is known as the "infarction of the pipeline". There is a phenomenon in homes in which for a long time there has not been maintenance or repair of capital engineering systems. From the inside, the pipes are overgrown with rust, salts, all sorts of garbage accumulates here. In the most difficult cases, to fix the problem, they resort to installing new metal pipes or installing plastic connections.
How to determine that the cause of uncomfortable sounds lies precisely in the presence of clogging inside the pipes? To diagnose blockage, it is necessary to dismantle any section of the water pipe and look inside. The presence of plaque and dirt on the walls of the pipes will confirm the conjecture.
Removing the blockage in the pipes can also be done by mechanical or hydraulic flushing. In the first case, it is necessary to drain the water from the problem area and use a thick wire, at the end of which a metal brush is fixed. For hydraulic flushing systems resort to the use of a powerful circulating pump, which is able to rapidly expel water through pipes under high pressure.
Old, damaged pipes
Damage to the mixer washer
Now consider the most common reason why the tap is droning. The most common problem is the presence of defects on the mixer shim. The latter can be worn, incorrectly installed or defective.
To fix the problem, you must do the following:
- Alternately open the tap for hot and cold water. This will reveal where the damaged gasket is located.
- Shut off the water supply in the apartment.
- Disassemble the mixer and remove the damaged gasket.
- Buy a new design element in the sanitary ware shop and install it.
- Collect the mixer, turn on the water and check if the buzz in the tap has gone.
Insufficiently secure hose fastening for water supply
Malfunction of the cartridge
Most modern single-lever mixers contain a cartridge that is responsible for the distribution of water flows. It is likely that the cause of unpleasant sounds in the water supply system lies in its damage.
To replace the cartridge, you need the following tools:
- Adjustable wrench;
- Screwdriver Set;
- Knife with a thin blade;
- Hexagon.
Before performing repair procedures, it is necessary to block the water in the apartment. Then, use a screwdriver to touch the button, which indicates which side of the supply is cold and hot water. Next, you need to unscrew the cartridge holding the screw with a hexagon. Finally, using a wrench, it is necessary to unscrew the clamping nut and remove the represented structural element.
You can find a cartridge similar to the one available in the sanitary ware shop. After completing the purchase, it remains only to assemble the system in reverse order, using the above tools.
Hose leak in the shower
To solve the problem, it is first of all necessary to check whether all the same gaskets are damaged. If the reason lies in this, you need to replace them.
Sometimes to the occurrence of unpleasant sounds when water is turned on in the shower, the rupture of the hose itself, namely its internal rubber tube, which is located in the middle of the metal sleeve, results. To deal with the trouble, it is necessary to seal a gap with a patch. However, those who do not wish to burden themselves with unnecessary work, it is best, of course, to buy and install a new hose.
Finally
However, it is recommended to resort to repair of sanitary ware only to those persons who already have experience of performing similar works. After all, ill-considered actions can affect the functioning of the entire water supply system. When performing incorrect repairs, it is possible not only to leak water, but also to create a serious emergency situation. Therefore, in some cases, to eliminate unpleasant sounds in the tap or elements of the water system, it is worthwhile to resort to the services of professional masters.
Similar articles
Trending Now