Repair of heated floors by own hands

Each of us cares about creating comfortable living conditions for his family, so many modern homes have warm floors. Thanks to this, our children can run barefoot in a cold winter in a uniformly heated apartment, without any fear of catching a cold. Such systems were appreciated by the owners of small-sized housing, because due to the absence of bulky radiators, precious square meters are vacated. However, no one is immune from this situation, when it may be necessary to repair warm floors.

The device and the most common causes of breakdowns

Floor heating is considered one of the most convenient ways of heating a living room. It is an electrical system built into the structure of the floor. Under the screed or tile there are wires providing uniform heating. The electricity flowing to the heating element passes through the thermostat, which allows you to set the desired temperature and provide the system on / off. In the case of excessive heating, the heating element automatically switches off. But like any other system, it can suddenly fail, and then it will be necessary to repair the warm floors. Before you start troubleshooting, you need to identify the cause of the problem. Among the most frequently encountered failures are problems with a heating element, a thermostat or a temperature sensor.

What should I do if there is no voltage at the input of the heating cable?

Before starting the repair of warm floors, it is necessary to check the presence of voltage at the input of the electrical system. If it is not, you should find out if the tripping device has worked. If the toggle switch is triggered, you just need to restart it, and if this does not help, you will have to find and fix the cause of the malfunction on the supply line.

What should I do if the heating cable is mechanically damaged?

In most cases, this breakdown occurs even when the system is installed, and for some time it may go unnoticed. Sometimes the damage is caused by inaccurate actions of the owners of housing themselves, who undertook major repairs. If in the process of using a saw or an electric drill, the integrity of the heating cable has been accidentally disrupted, it will be necessary to independently open the floor covering and find the fault location. Burned or torn veins must be carefully cleaned and connected by means of diameters suitable for the diameter, which are subsequently crimped by pressing tongs. In places of connection a shrink sleeve is attached, heated with a construction hair dryer. In the process of cooling, it contracts, firmly sealing the joints. After that, repair the screeds of warm floors.

What should I do if a temperature sensor or temperature controller fails?

Noticing that after the warm floor has warmed to the set mark, it still continues to bask, you can be sure that the temperature sensor has failed. In this case, the repair of the electric floor of the electric is reduced to the replacement of the defective item. It is quite easy to do this. To do this, remove the broken part from the corrugated tube, not forgetting to mark the exact place in which it was located, and replace it with a new one. If the installation of old equipment was carried out with a violation of the technology, without the use of corrugation, an air temperature sensor attached under the thermoregulator can be installed in its place.

If the cause of the failure lies in the faulty thermostat, then the repair of warm floors is reduced to its replacement.