The heating system of a private home should be thought through as carefully as possible during the construction phase, so that many associated problems can be avoided. This will be very beneficial when the installation of heating pipes and boiler room begins. Technical niches should be provided for different needs, a separate room should be allocated to the boiler room, if there is any need for it.
Installation of heating pipes and the system in general can begin only if the roof and windows are already installed. At the moment they are made to be laid by the method of concealed wiring, that is, using shtroby or directly in the floor. Laying the pipes in the screed is most appropriate, but if there is no such possibility, you can lay them directly in the walls. This method is used quite often on the second floors, where the floors are wooden. It turns out that the installation of heating pipes is most correct to produce, while the screed is not flooded, but the walls are already plastered. If you place the radiators to the plaster, then they will need to be leveled. In some cases, all installation operations are performed in two stages: first, the pipes are made with a margin, and then the radiators are attached, which are connected after the plaster. With this method of time to work will take much more.
It is necessary to adhere to a certain technology. First you need to hang all the radiators, outline the boundaries of the strob for conclusions, and then patch. When this is done, place the radiators in their place, make the heating pipes, and then connect them. In places of withdrawal, they must be fixed by means of cement mortar or alabaster. When everything is cold, you can remove the radiators. They should be folded away from the finishing works. If this is not done, the film will not save them from damage and dirt.
You can make a hidden wiring even when the house has finished finishing. The installation of heating pipes can be made along the walls by placing them in a special box. This layout is called plinth. Some western manufacturers offer already finished plinth heating wiring, which has ready materials and components. However, you can do it yourself. This is done using a plastic box that is similar to the one used for electrical wires.
Installation of heating system: pipes
If a tee wiring is used, it is better to lead the pipes along the walls. However, it is necessary to leave an indentation of approximately 150 millimeters, which will help to avoid damage when you start to nail plinths. Modern systems do not assume compliance with a certain bias towards the cranes, as this is no longer necessary. However, the installation of heating pipes should still be carried out in accordance with certain rules. It is important to ensure that in them can not form air jams, that is, some humps. If this can not be avoided, then a special vent valve should be installed at the top.
You can use metal-plastic pipes for heating, the installation of which is not particularly difficult, or you can use other options available to you.