How to glue a tile on a tile with your own hands

Specialists recommend laying a new tile only on a cleaned and prepared surface. But it happens that it is not always rational. This option is possible in the event that the walls in the house are rather fragile, why not better to break their tightness, or you just try to save time. Then you can use the instruction that tells how to glue a tile on a tile, and do not spend extra time removing the old layer.

First step

First, check if all the pieces of the old tile are kept well. If there is at least one thing that staggers, boldly remove it. Gently pick up the chisel and gently remove this tile. Try not to hurt the neighbors, otherwise you have to shoot everything. Pits in this place should be carefully covered with glue or cement mortar. A trowel for such work should be with a flat edge, this will help create an ideally smooth surface.

Second phase

After the work platform is leveled, you can proceed to further work. The surface must be cleaned of dirt and grease. This procedure is considered mandatory, otherwise the new tile will quickly peel off, and you will have to start all over again. This is especially true for the kitchen, where a thick coating is always present. Even if you do not see noticeable spots, you still need to clean the surface. For this, a stiff sponge and a cleanser with an acid that breaks down fat are perfect. Rinse with water and allow to dry.

The third stage

What can I glue tiles? If the old coating is glazed, it will necessarily have to be primed. And if the previous layer is dull, this operation can be skipped - the bonding ability on both sides is excellent.

Fourth stage

Let's talk about how to glue ceramic tiles, so that there is no problem with the reliability of the new coating. Approximately 12 hours (or better - per day) before the work on the prepared surface should be applied a thin layer of glue. This will help ensure even greater adhesion strength. This stage is considered the most important in the matter of how to glue a tile on a tile. If you skip it, then soon the top layer may fall off, and you will have to start work again. This is not only the cost of extra money, but also the loss of time.

The fifth, the last stage of how to glue a tile on a tile

When the base layer dries, you can start applying tiles. Glue must be spread over the entire surface of the plate and on its sides. Lay out the material in rows, using for equal distance crosses for aligning the seams. After all the tiles are laid out, you need to let the surfaces dry out (at least a day). And only then you can apply the grout for the seams.

Results

We examined how to glue tiles on the tiles with your own hands. Of course, it is not bad if this work will be performed by a master who will be able to take into account all the nuances existing in this peculiar case. But, perhaps, you can do it yourself, having carefully read the instruction offered here.