How to disassemble iPhone 3GS: manual

Before you begin to decide how to disassemble the iPhone 3GS, you need to understand that you carry out this operation only at your own peril and risk. If you accidentally damage any parts, then the technical service can refuse to help you, and this happens in most cases. Therefore, in advance, we recommend to think whether you will repair yourself or still trust the experts.

Necessary equipment

In order to disassemble the iPhone 3GS, you need to have at hand a set of special tools. The work will involve a collection of clock screwdrivers, a spoke or a plastic blade with a thin tip, however, you can use a mediator. It will also require the use of a thin metal knife, but nevertheless the presence of a scalpel is recommended. For best illumination, use a carrying case or a desk lamp. If you need to replace the protective glass on the screen of the device, in this case it is necessary to be at hand a hair dryer.

Order

So, let's get down to the question of how to disassemble the iPhone 3GS. We will act in a certain sequence. If you use our instructions, in this case, be sure to remember that all items must be observed in strict sequence, otherwise you can only damage your device.

Display

The first thing you should look at the iPhone. If you carefully studied it, then on the bottom you will notice two bolts, which must first be unscrewed. When this is done, you will be able to open the screen unit, this is done as neatly as possible, otherwise the loops can be damaged. To remove this element, you can use a thin plastic or metal object, but still we recommend using the suction cup, so you do not damage the edges of the glasses. If you needed to learn how to disassemble the iPhone 3GS, then in no case should you rush and be sure to follow the instructions. When the screen part is partially moved and raised, you should start by disconnecting the motherboard plume. The required item is on the top right of the device. After this loop is disconnected, it is necessary to disconnect the second one, which is intended for the sensor. The third leads to dynamics. You should also disable it, in order to be able to completely detach the screen part. If everything is done correctly, then the module we are interested in will easily separate from the bottom of the device. Now you know how to disassemble the iPhone 3GS to replace the screen or protective glass, but if you should continue the process, for example, to install a new motherboard or battery, in that case, follow the points that we will give below.

Deep repair

Pick up the bottom of the device. From the front side you can find the screws, on each side of them there are three pieces. We unscrew these elements and separate the display from the glass with the frame. In fact, care must be taken when separating the display. If you want to replace the glass, in this case it will need to be heated with a hair dryer, but if you do not plan to do this, we will not need to use the heating device at all. How to disassemble the iPhone 3GS, now you know, and if you act strictly on the instructions given, then you can do without the services of specialists and do not damage anything, but, on the contrary, fix the problem yourself. That's all we wanted to share in this material. Thank you for your attention. We hope that the instructions will help you.