Eliminate the condensate on the toilet bowl

You made repairs in the toilet and rejoice at the comfort and comfort that reigns in the room. A clean and fresh room that smells of freshness makes you think that all problems are in the past. However, you are surprised to find the condensate on the toilet bowl. Your first thought is that the equipment is defective. But after a thorough check, this version is not confirmed, and it has to be abandoned. Some immediately calm down and decide not to pay attention to small droplets of water. They are easy to wipe with a cloth. Why worry again.

But not everything is so simple. Moisture, slowly gathering in brooks and draining to the pipes, will gradually lead to the formation of rust. The toilet will increase the humidity level, which will be a favorable environment for the appearance of fungus and mold. In the most severe cases, a puddle on the floor of your bathroom will penetrate the floors to neighbors who are unlikely to be delighted with the wet spot on the ceiling.

So why does the condensate continue to work hard on the toilet bowl? Remember the forgotten lessons of physics. The water entering the drain has a very low temperature. It goes directly from the pipeline and is not heated along the way. But in the bathroom itself is warm, sometimes even hot. Accordingly, a similar temperature difference causes the appearance of water droplets on the outer wall of the toilet bowl.

What to do, so that the condensate on the drain tank is no longer bothering? First of all, you need to again check the valve for various malfunctions. So you exclude the possibility of a constant loss of water and, consequently, its unceasing set. If this factor is not eliminated, then there is nothing to dream about the moment when the condensate on the toilet bowl stops pestering you.

Next, try to minimize the amount of water drained. This can be done by adjusting all the same fittings. This solution also saves you money, because the meter will show a steady decrease in cold water consumption. Pleasant bonus, is not it?

The next step, allowing lime condensate on the toilet bowl, is associated with improved air circulation in your toilet. The room should be well ventilated, and to do this, clean the ventilation system. Did not help? Install the electrical power system.

Now it was the turn to take care of a slight increase in the degree of water entering the pipes. A special boiler, which provides heating to an acceptable room temperature, will help to cope with this task. In some cases it may be sufficient to carry out work on the sound insulation of water pipes.

Condensation on the toilet bowl can be a consequence of very thin walls of the product. You can try to pick up in a specialized store plastic special insert. Or radically - to change equipment to a higher-quality model with double walls, the air layer between which creates the necessary buffer, not allowing direct contact of cold water and the external facade of the drain system.

Only an integrated approach will save you from the kind of toilet that weep with burning tears.