By what principle are the floors in the baths collected by their own hands

The device of floors is one of the important moments of construction of a bath. With their hands they are made quite simply. But it is worth to know a couple of points. The floors in the bath are in most cases made of wood, but also come from concrete. In this case, only two types of construction are distinguished - flowing and not flowing. In the first case, water drains into the cracks, specially left in the floor, and absorbed into the ground. And in non-flowing water flows into a special hole and gathers in the water header. After that, it flows out of the structure. The second kind is advantageous, since such a floor is much warmer. Consider how to install floors in the bath with your own hands.

We pass directly to work.

Before manual installation of a floor it is necessary to lay sexual lags which are made of a file of a pine. On the logs are attached boards made preferably from the same tree. The floor must necessarily be under a slight slope so that the water can easily drain off. Logs must be laid transversely to the flow of water. Under the center of each you need to locate the support chairs made of brick, wood or concrete. Under the site, dig holes (about 40 cm in depth), compact edges and bottom and fill it with sand (about 10 cm), carefully compact. Above the sand is laid a layer of gravel and also rammed. Next, pour the area with a thick cement solution and leave to dry for a day. This is how ready-made floors look in the bath-house, made with their own hands.

We lay insulation material

Before installing the support, a waterproofing must be laid on the site. The height of the supports must end there, where the ends of the lag run out. After installing the supports, you must begin to create the underground ground. You can realize this in the following ways: fall asleep rubble, if the soil is sandy, or arrange a tray for water drainage, if there is a possibility that the soil will not absorb water well.

What to do with leaking floors

Let's consider such situation when the collected floors in a bath by the hands are proceeding. In this case, the surface of the underground must be strengthened with expanded clay. If the underground is made, and the sex lags are laid, then it is possible to begin work on the flooring of the boards. Collecting the floors in the bath with their own hands flowing kind, you should put uncircumcised and pre-planed boards. Also they need to be attached to each lag by at least two nails. After the flooring, it is required to treat the linseed oil in two layers. If you apply paint to the boards, they will dry out badly. Not flowing flooring is better to make of boards of coniferous breeds. And the flooring should be made so that the groove was located inside the bath. Then you need to lay a waterproofing layer.

A little in conclusion

As you can see, making the floors in the bath with your own hands is not so difficult, as it may seem at first glance. Therefore, before you hire a team, think: perhaps you can deal with this case yourself. The main thing is to take into account the nuances. Good luck in your construction!