Understand the question: "How to connect two computers to the local network?"

Sometimes users who have a couple computers at home or a computer and a laptop want to establish a network between them in order to transfer files from one device to another without resorting to the help of media. And then the question arises: "How to connect two computers to the local network?" This can be done through a direct connection.

It is worth noting that if everything is done by yourself, then it will be quite difficult. You can make a cable that connects the computers, on your own, or buy it in the store already ready. Suppose you bought the cable, that is, you do not need to mess with it. When deciding how to connect two computers to a local network, it should be noted that the cable should be connected directly to both devices. If there is a special indicator on the Ethernet controller , it should glow green and sometimes flash. In the event that the indicators do not light up, or only light at one end, you should check the quality of the cable crimp and the absence of mechanical damage to it. It is also necessary to check the availability of special drivers for the controllers on the computer, and also to make sure that the hardware is installed correctly.

Settings

We continue to understand the issue of "how to connect two computers to a local network." Now we need to go to the process of setting the parameters in the operating system itself. To do this, you need to open the control panel and find the network connection option . Among already existing connections, find "Local Area Connection". You must open the properties of this item by clicking on the right button of the manipulator. In the appeared window it is necessary to find "Internet Protocol", then again to call the properties.

In order for you to get a local network of two computers, you need each of them to assign a specific network address that will allow you to identify it. Typically, the IP address is written in the standard format: EFGH, where letters correspond to numbers from the range 0-255 for each. You have the ability to select absolutely any numbers, however it is recommended to set up addresses within 192.168.0.1-192.168.0.254. It is important to remember that the last number should not coincide on the connected computers, otherwise an identification error will occur. The most correct way is to choose the addresses sequentially, so it will be easier for you to navigate. In all three windows, click "OK". On the second computer, you must perform similar manipulations, remembering what should be its network address.

If you are talking about how to properly connect a local network, you should double-click the "Local Area Connection" label after all operations, after which the status window will appear before you. With the correct setup, you will see a message about the presence of the connection. If there was an error during the configuration, the connection will be limited.

Now you know how to connect two computers to a local network, so go ahead. The next step is to allow shared folder access. This is done so that you have the ability to move files between computers. To do this, you need to right-click on any folder or disk, and select "Sharing and Security" in the pop-up menu. In order to make the folder accessible to the second computer, you must tick the appropriate item. Everything, the folder is accessible for work from other computer.