Studio monitors - the choice of professionals

In the studio, the acoustic system plays a significant role. In the home studio should abandon the studio monitors of the far and middle fields, since the possible area does not exceed 20 square meters. However, even work with near field equipment because of the environment, decoration and acoustic properties of the room is difficult.

Location:

Studio near-field monitors should be located so that the distance between them is from 1.2 to 1.5 meters, and the position of the workplace with their place formed an equilateral triangle.

Installation

Studio monitors should be removed from the wall near which they are located, by 30-40 cm. And your workplace should be spaced from the back wall and side walls at the same distance as before. The height of the monitors is chosen in such a way that the peepers make up one plane with your ears. Ideally, you should get exactly this arrangement, but the room at the same time should have an area of 13 to 20 square meters, not taking into account the space that occupies the furniture.

Decorating a room for a studio room

In most cases, the correct finish at home is simply not realistic, so the challenge is to try and get closer to the required results. First of all, it is necessary to muffle the wall located behind the monitors. The first option: you can muffle the entire wall, placing on it a curtain, carpet, foam rubber - all that will make it as difficult as possible to reflect the sound. The second option: only a part of the wall is deaf: from the sound-absorbing material it is required to cut out two pieces, the areas of which will be 2-3 times larger than the dimensions of the rear wall of the studio monitor. These pieces need to be hung behind the monitors, while allowing a small offset to the center. It is also necessary to muffle the rear wall, as well as the side walls, either completely or partially. If you are going to muffle the walls partially, then you should find the areas of primary reflection. You need a mirror and assistant: you are located in the workplace, and the assistant at this time walks along the wall. Where you see the reflection of the monitors, you need to fix the absorbing and scattering plates. In the same way you need to do with the workplace: the mirror is placed on the desk or on the console, you look from the workplace, while you need to ensure that the reflection of the monitors disappears in the mirror. For a studio in an apartment, the absence of primary reflections is a big plus.

Connectivity

To properly connect the passive speaker to the amplifier, you need to pay attention to the polarity. In the event that studio monitors are included in the antiphase, all efforts to create optimal conditions will come to naught. It is possible to detect antiphase by the following features: absence of low frequencies; Appearance of chorus; Listening is accompanied by uncomfortable sensations - a sound hole; The equalizer does not work correctly in the lower range. To check the polarity, you can use a regular battery: connect it to the speaker wires, while the low-frequency speakers should work in one direction. Care is required - it is possible to burn the pinch if you have a bad filter at high frequencies.

The standard of sound for more than 20 years is Yamaha ns-10m

Studio monitors Yamaha - a choice of professionals. Initially, this model was released as a Hi-Fi acoustic system intended for listening to music at home, but thanks to the technical parameters, this household model was used by professional studios. Today, such a studio monitor can be found in almost any recording studio.

Selection of professionals

Studio monitors Yamaha is still relevant and used by professional studios. Rapid signal attenuation is perhaps the main trump of this model, which provides greater honesty and transparency of the reproduced material.