Men's haircut under the typewriter: the process of performing

The hair clipper is now considered very popular and, most importantly, an economical purchase. Advantages are planned immediately: do not have time to visit the hairdresser, sit in line, because you can cut your hair at home at any time convenient for you. Of course, these are undoubted advantages. But other than that, you also need to know how to use a typewriter to create a beautiful male haircut.

Haircut under the machine: a description of the process

First, you need to comb to hair that lay in its natural direction and order. To start a hairstyle the man needs from a forehead, and if at it or him long hair then they should be combed forward. Then raise their comb and place the machine in the place where they begin to grow, that is, the roots.

If you want to make short men's haircuts for a typewriter, then you do not need to wet your head before starting the process. Using the largest nozzle, trim the hair in the area of the crown, and then gradually lead the machine to the side of the temples. Note, it is necessary to introduce the instrument against hair growth, and not vice versa.

When performing male haircuts, you can do a lot of movements, pressing the nozzle to the surface of the head, but in no case do not change the angle and the distance between the typewriter and the head. The more often you comb your hair and pass it by the machine, the more quality the haircut will be, and also the final result.

The haircut under the machine is always performed so that the comb lies in the left hand. This allows you to carefully comb the hair and just press them to the palm of your hand, slightly holding your fingers.

Men's haircut under the typewriter is performed by strips, first in the middle of the head, and then sideways, and so on up to the ear (according to the same scheme it is performed before the second ear). Replacing the nozzle with a smaller one (2 times less), go to the back of the head. Start the movement from the bottom, then go higher. And on the back of the neck you need to press the machine to the head, and having risen to the crown, you need to lift it slightly. This will allow to equalize the difference between the length of the hair and make the transition smoother. Using the same nozzle, you need to cut the whiskey, moving in a direction from the bottom to the top.

Above the auricle, the hair grows in opposite directions - towards the temple and neck, so the haircut under the machine in this zone is performed with a change in the direction of the tool, but only against the growth of the hair. It is recommended to slightly bend the left ear with the left hand, and the right one with the little finger of the right hand, so as not to injure the skin.

The haircut under the machine ends by removing the nozzle from the blades. For a better result behind the temples and on the neck, you need to make a fringing without it: the blades will not leave any gun on the neck and cut the hair completely.

At the very end of the work, check the length of the hair on the entire surface of the head with a comb. If there are irregularities and inaccuracies, you can correct them with thinning scissors.

For long service of your machine it is necessary to look after it. After each haircut, you need to work it well with a brush, removing all the hair from the surface of the knives. And, of course, do not forget the basic rules of using the tool.