HomelinessPest Control

How to get rid of the fungus in the bath: tools, tips

Mold (fungus) in the bath is a real threat to people and their property. It not only causes destruction of buildings, but also affects human health. So, it can cause diathesis in a child, a severe allergy, which can go into asthma, migraine, cardiovascular disorders. Fungus in the bath - a frequent phenomenon, because he loves the humidity, and in this room is almost always a condensation - the ideal conditions for reproduction. So, if you are faced with such a problem, you need to take emergency measures. In this article you can learn how to get rid of the fungus in the bath and prevent its re-emergence.

Dampness is the cause of the appearance of mold # 1

In the baths, humidity is always increased - this is a regularity, and nothing can be done about it. If there is no additional heating in the building, most often these are wooden baths, then you are in an increased risk group. The fact that the heating allows you to dry the air, walls, and the likelihood of the appearance of the fungus is reduced. No heating - the sauna dries up on its own, the walls stay moist longer - this is good for mold.

The reason for the stagnation of moisture can also be covered in such factors as lack of ventilation or its improper equipment, blockage. In this case, the fungus first appears in places where the air movement is the weakest, and then, getting stronger, it spreads without problems around the wall, and light drafts do not bother him any more. If it's a matter of ventilation, you need to create it, reinstall it, clean it, install additional fans that will help drive the air, dry the room. Next, we'll tell you how to get rid of the fungus in the bath, but for now consider another reason for its appearance.

Insufficient cleanliness

Many bath house owners assume that this is the cleanest place, because there is always wet, and the washing of the ceiling and walls is neglected, considering that it is enough to clean the floors, shelves and accessories. Fungus like dirt, and coupled with dampness, so in general the ideal conditions.

If you have a proper ventilation, even installed heating, and mold all the same appeared, then there is not enough hygiene.

Than to arm?

Before you get rid of the fungus in the bath, you need to think about your own safety. By cleaning the mold from the surface, you spread its spores in the air, and they can get into the lungs. Before the start of the fight, you should purchase the following protective equipment:

  • The respirator will help to protect a mucous nose and lungs from hit of spores of a fungus and chemical substances by which you will deduce a mold;
  • Rubber gloves will protect your skin and nails.

This is a necessary outfit, and without it, do not start fighting with the fungus.

Is it difficult to eliminate the fungus?

Mold spores are very mobile creatures and, only appearing, begin to spread throughout the room. To treat only visible lesions is not enough, anywhere else can be black and white fungus in the bath. How to get rid of this pest? The first thing is to assess the situation, find all the pockets of defeat, take out of the room everything that is not nailed, and begin processing all walls, ceiling, shelves, floors. It should be noted that the outfitted inventory must also be processed. Get rid of the fungus, even in the first stage is very difficult, not to mention the fact that the spores could have time to penetrate deep into the boards a few centimeters, to hide in the cracks. Where to begin?

The first step to getting rid of mold

To begin with, you will need to mechanically clean all visible lesions. Especially carefully examine every inch, even an incomprehensible speck can be a fungus, so do not lose sight of it.

First of all, slowly, carefully, so as not to spread the spores throughout the territory, use a spatula to remove layers of mold, walk through them on all the cracks and corners where the fungus was found. Mechanical cleaning is very important, it allows you to remove all surface lesions that protect the deeper. After this, you can proceed to a chemical attack.

Do not forget about ventilation

After the mechanical cleaning is carried out, it is necessary to proceed to ventilation. In most cases, it also has a fungus, there may be a source of infection. First, treat the ventilating system with antibacterial agents, it can be ordinary alcohol. It perfectly dehydrates, that is, it dehydrates the surface, is capable of pushing moisture out of the narrowest slots, besides it destroys mold spores. Do not forget that this substance is highly flammable, therefore, after the treatment, thoroughly ventilate the room and proceed to the next stage.

In the hardware store you will find special primers. They can simply protect the surface from the appearance of mold, and can also contribute to its destruction. Choose a suitable product for your wood and treat it with ventilation. Now you can treat all other surfaces in the room with this primer. Next, consider how to get rid of fungus in a bath in other ways. There are many, we offer the most effective.

Sulphur dioxide

It sounds awesome, but there is nothing easier and more effective than removing the fungus in the bath with sulfur. This procedure is very unpleasant, the substance smells bad, is dangerous for all living things, so before using this method, make sure that all possible slots are tightly closed. Plug tightly the ventilation, the pipe, if the sauna is heated by the oven, all small slits and holes through which a dangerous substance can penetrate outside. Sulfur gas is very dangerous, it will completely eliminate the fungus, but in no case you should not be exposed to it.

If the floors are wooden, it is better to take a ceramic container, if concrete, then it can be metalware. Put a few pieces of sulfur in there, from the calculation that for one hundred cubic meters of space you need two hundred grams of substance. Set fire to sulfur, it will release gas, harmful to the fungus. After she began to act, immediately leave the room and close behind you close the front door. It is important to use a respirator during arson and during further action.

At least six hours, and preferably nine, take a box of quicklime. Go to the bath, remove the remains of sulfur, put in its place a box of lime. It will neutralize the remains of sulfur dioxide, dry the room, absorbing excess moisture. The box should be in a bath for 24 hours, after which the room is ventilated as much. The bath can be operated immediately after it is ventilated.

How to remove the fungus in the bath with bleach?

This is also a good option, but for a wooden bath it is best not to use it, since bleach is not too safe for wood.

After cleaning the walls of mold by mechanical means, it is necessary to dilute the said substance in a small amount of water and walk through all surfaces with this solution. There is another option: take 25 milliliters of 40% formalin per liter of water, add chlorine lime and treat the floors, walls, ceiling, shelves.

How to get rid of the fungus in a wooden bath?

Sour gas and primer are ideal for wood, they do not harm it, but there is another gentle method of getting rid of mold in the bath. It is necessary to take on one liter of water 22 grams of vitriol of iron, 44 grams of alum alum and 18 grams of common table salt. Dip the roller into the solution, treat all surfaces after mechanical cleaning from the fungus.

You can also use the following recipe, but pre-heating the mixture to seventy degrees. You need a half tablespoons of vinegar (not acid), half a kilo of boric acid and a kilogram of borax. Dissolve the ingredients in a small amount of water.

Both prescriptions are effective, but they are not very strong, they can not remove the entire fungus on the first try, so treat again one month later.

Prevention

Of course, preventing the appearance of fungus in a bath is easier than getting rid of it. If you have ventilation, do not forget about airing. They should be produced not only after the operation of the bath, but also when you do not use it, because water can stagnate, and then evaporate. Ventilate at least six times a week for six hours.

Carry out preventive treatments with iron sulfate or other substances. Remember that after using chemicals, you need to ventilate the bath, then rinse the walls so as not to harm your health. We hope that this publication on how to get rid of the fungus in the sauna can help.

Similar articles

 

 

 

 

Trending Now

 

 

 

 

Newest

Copyright © 2018 en.unansea.com. Theme powered by WordPress.