How to fill a fishing line in the reel of a trimmer and which is better for this use?

Very often those people who in private possession have cottages, orchards, are faced with the need to care for the lawn on the site. In such cases, simply do not do without a conventional hand braid or trimmer. The first slowly fades into the background, and the people who use it are becoming less and less. The trimmer works automatically and does not require much effort. Especially since there is no special skill to use it.

How does the trimmer work?

The principle of operation of such a device is that the grass is mowed by a special fishing line mounted on the fast-rotating head. The number of revolutions per minute can reach 8000. For a short time, the line is worn out, or rather erased. Then the villagers have a question: "How to fill the line with the trimmer spool"?

Types of trim tabs

First of all, in order not to resort to frequent substitutions, it is better to use a denser line. The number of its types and manufacturers is simply amazing. The main parameter of the line for the trimmer is its diameter. It varies from 1.6 to 3.2 mm. The most common species is a 2-millimeter line. However, it must be selected according to the type of trimmer that you have.

There are several variants of the line cross-section. So, it can be round, square, in the form of an asterisk with sharp edges. The most effective is the last option. However, its use is only on powerful braids and you need to know how to fill the fishing line with the trimmer spool. Therefore, it can be concluded that the more powerful your motokosa, the line must be thicker.

Such a process, like winding a line on a trimmer, is not difficult, but it has its own peculiarities. To begin with, it is necessary to select the correct line, the diameter of which is registered in the device's passport.

First, unscrew the coil cover. Be careful, as the carving can be left and right. The left thread is necessary so that the head of the braid does not untwist during operation.

Filling the line in the trimmer

Before you add the fishing line to the trimmer spool, measure from the skein 5 m (the amount of line is set on the trimmer on average). Then fold it exactly in half, in order to find the middle. The obtained center should be inserted into a special slot, which is located on the coil. After this, wind the line in the direction of the arrow, which is on the head.

There are such models in which the place of winding is divided into two halves. Therefore one is often wound clockwise, and the second is against. After winding the line completely, its ends are passed through special holes. Top is put on the cap on the head.

From the above, it follows that the very process of replacing the line is not complicated. After performing such manipulation as winding the line on the trimmer spool , several times, you will bring this process to automaticity. The only thing is to constantly monitor the condition of the line, in order to avoid its rupture at the time of work on the site, when a spare skein at hand may not be.

Now you know how to fill a fishing line in the reel of a trimmer, and you can do it yourself without much effort!