How is the bath trimmed from the inside?

The internal finish of the bath includes the installation of the floor, the ceiling and wall lining, the installation of the oven and the furnishing of the furniture. Such material, like wood, is ideal for facing the room. There are some recommendations that will help make the steam room safe, durable and warm.

Finishing of the bath from inside is carried out not by any lumber, but only dry natural wood. It should be environmentally safe and resistant to temperature changes.

When using coniferous trees that release resin, it must be specially treated. Experts say that it is better to use hardwoods when the interior is trimmed.

Material selection

Popular materials are abash, linden, aspen, alder and cedar. In the olden times, aspen and linden were used, which satisfied the basic requirements.

Aspen Properties

It is often enough to finish the bath from inside the aspen, appreciate this wood for its resistance to changing temperature and humidity.

Pluses:

• Fine structure of fibers;
• softwood;
• High resistance to humidity and temperature changes;
• Low density;
• Ease of operation.

Disadvantages:

• Cracked;
• Has a large drying ratio.

At present, such material as abash has become popular in construction. Finishing the bath from inside with African oak was first performed completely by accident. Once, materials were delivered to Finland, which were in boxes made of oak. The box, accidentally caught in the sauna, did not heat up, which caused the Finns to interest in wood.

Abashi properties:

• Low specific gravity;
• elasticity;
• Simplicity of installation;
• Low thermal conductivity and permeability;

Floors

Usually choose a floor covering that retains heat. Builders recommend to mount board floors in the dressing room and steam room. For coatings, you can use both coniferous and deciduous species. First lay the wooden logs, processed antiseptic. Between them insert sheets OSB, and from above establish a waterproofing. The heater is stacked in a staggered manner, and the top is already covered with a whole piece of steam insulation. Above it to the lags screw bars. After that the floor is finished. In a washing room, such a foundation is not made, but only install wooden grates on a concrete floor.

Walls

Finishing of baths from the inside is made only with high-quality wood. The walls of the bath must be insulated with thermal insulation. The materials used are parchment, foil, jute, stone wool. Do this as follows. For example, install a moisture-resistant gypsum board. Then cut off the heat-insulating material and insert it into the frame, gluing with adhesive tape. Above are already stuffed with lathing and facings - lining. The use of a special reflective foil in a therma is an important nuance. It does not allow outflow of hot air, and the bath heats up faster. The use of mineral wool and aluminum foil is very effective for the steam room.

Ceiling

For the roofing of the ceiling, wood with a small resin content is used. Thermal insulation material is used to create a comfortable temperature. The ceiling in the waiting room is also chipped with heat insulation, and the joints are glued with adhesive tape.

In construction organizations, among other services there is such as finishing the bath from the inside. Photos of ready-made saunas and steam rooms are shown to customers. Interior decoration of the bath is a rather complicated process with its secrets. Only the professional builders will perform the finishing work.