Feeder for the feeder with your own hands as a way to save money

It is not necessary to explain that feeder feeders are the basis of feeder fishing, its essence. And the saying that, as you feed, and halves, the most applicable to this type of catching. Very often when fishing there is a situation where the place is rather catchy, but the conditions of fishing are not simple. At the bottom there can be a lot of debris, or driftwood, or the brow is quite steep.

Feeders in these places are usually stuck, and it is impossible to get them from there. For one fishing can leave up to ten, and even more feeders. And for many, such an issue, like a feeder for the feeder with their own hands, is sharply on the agenda. In this article we will consider the most popular way among fishermen for the production of feeders.

So, you need to say right away that the feeder for the feeder will reduce your expenses on this item by an order of magnitude. And the quality of production will be acceptable if you learn how to do it correctly. Feeder for the feeder, made with this hands by this method, will more than once help you out fishing.

We will make feeders from plastic bottles. They will fit almost any feeder. Fishing with this type of feeder is just as good as if you were using store options.

The manufacturing process is quite simple - you need to take a two-liter plastic bottle, cut the top and bottom so that you get a cylinder without the bottom and top. Then cut it in such a way that its side part in the form of a strip turns out. Then cut this strip across half. Form the two parts cut into 3 strips each so that the dimensions of the resulting strips were 5 cm by 12 cm. As a result, you should get 6 strips - this will be the material for the feeders.

Next you need sheet lead. It also needs to be cut using special scissors on strips. The length of the strip should be about 8 cm. If the lead is the same thickness, then you can only change the width of the strip. Changing the width of the strip, you get a different weight feeders. Attention, this is a very important parameter. You need to know exactly what weight feeders are needed for your fishing conditions. To calculate the weight of the strip, multiply its dimensions (length, width, thickness) and multiply by the density of lead 11.32, gain weight in grams.

After we received strips of lead and plastic, we proceed to manufacture. Feeder for the feeder by its own hands in appearance does not give way to the purchased one, if everything is done accurately. To do this, take a strip and twist it into a cylinder. Next we need a preheated soldering iron. With it, we fasten the strip to the ends in three places. Such rivets are obtained. They will be respectable, tested in practice. When we got the body of the feeder, proceed to fixing the lead strip. To do this, take the pliers and at the ends of the strip we make them and attach them to the trough.

Next, you need to make an ear for the feeder. To do this, we take a thin wire and make of it a twist that resembles a clothes rack for a wardrobe. Having received such a piece, we pass it between the lead and the cylinder, gently with the help of pliers jaw. As a result, we got a ready feeder. Next, you need to make holes. They are needed so that the feeders used for the feeder quickly wash out and dust. With the aid of such apertures, the feeding trough performs its work better. The holes must be made using the same soldering iron, they are made evenly over the entire surface of the feeder.

Everything, the feeder for the feeder is ready.