Discharged battery: how to light a car?

The winter cold period is always a test for motorists and their iron horses. A common problem that many people have to face is a discharged battery. Although he can bring not only in the winter. Not lit at night in the cabin, unliquidated headlights, alarm, screaming for a long time - all this can cause the battery to discharge, and, consequently, a bad mood.

In people who are alien to the problem of cars, the question of how to light a car is puzzling. But the motorists know how unpleasant the situation is when the car's energy is over, and there is no spare battery. What to do in this situation?

First you should check whether the battery is guilty of the fact that the car does not start. After all, there are other possible reasons. If, when the ignition is switched on, the headlights light up and the radio is on, you need to look for the cause in something else. And if you turn the key, there is no action on the part of the machine, you have to think how to recharge the battery.

You can use the services of special visiting services that will come and recharge your battery, but it is not always convenient in time, and you can stay away from populated areas. Therefore, in addition, how to light a car from another car, there are no options.

To get started, you will need special starting wires of the appropriate length with metal clips at the ends, since it is simply impossible to light a car without them.

Next, you need to find a car enthusiast who is ready to help and provide his car for lighting. The car "donor" should be serviceable and full of energy, preferably with the same engine volume as your car. If the "donor" is found, it's time to figure out how to properly light a car.

Cars are installed as close as possible, but without contact, and put on the parking brake. All appliances that consume energy (lights, radio, stove, air conditioner) must be turned off. The batteries of both cars must be airtight.

The starting wires have clamps (+) red and (-) black. Using protective gloves, you must first connect the pluses of both batteries with red clips. And the first necessarily clings to the discharged, and the second - to the battery "donor".

With black clamps, the wire is first connected to the minus of the source, and then to the negative of the discharged battery, and, better, to the metal of the engine or starter, the so-called mass.

Before you light a car, you must carefully check the correct connection of the starting wires. Now you need to get an assistant for a few minutes, then check the condition of the recharged car. If it is wound up, do not immediately remove the wires, let both motors work a little.

The wires are removed in reverse order, first the black clamp from the mass of the charged car and from the minus of the accumulator-donor, then red from the plus of the donor and from the plus of the charged battery.

That's the whole answer to the question of how to light a car. It should be noted that this is not difficult, but it is quite dangerous, therefore it is necessary to observe the safety precautions and the rules of battery operation.