Bream on donku - exciting and productive

Fishing for bream on donka is one of the most popular types of fishing. Usually several gears are used, which are installed along the length of the shore.

Best bream on dunk is caught in standing or slow water. Fish that go out to feed at the same time and, as a rule, in the same places, become easy prey.

Catch her bottom fishing rod without baiting the fishermen called "doing absolutely useless." Therefore, many of them use a spring feeder in which to place a bait with a sufficiently high viscosity, so that it does not fly off when casting and evenly scattered on the bottom. Adjust the mixture can be river sand or grape "Hercules". The feeder descends in the water, and the lure drops out of it. Experienced fishermen know that bream on Donkey is better when using a leash with a length greater than half a meter.

After casting the trough for a while should be in a stationary state, and then you need to drop some part of the complementary meal into the water with sharp jerks. Then, pulling the tackle, you must again score it, do a second cast, trying to get into the same place. This procedure should be repeated until a supermarket is formed at the bottom. And only after that you can throw a tackle with leashes.

Bream on Donkey is better caught when the right place for fishing. Tack must be thrown downstream or higher from the pit. And it does not matter whether the fish comes into it or goes out, the main thing is that after discovering the bait, it becomes interested, and then the bite will necessarily follow.

At this point, you should not hurry with the cutting. Usually due to the weight of the sinker and the length of the leash the bream is self-interspersed. Do not rush and vypazhivaniem, especially if the prey was a relatively large fish. It is necessary to lead its definite time, exhausted, and only after that to direct in a pod.

Many know that the best harvest is bream at night. On the donku this fish can be caught at any time of the day, however, the dark poklev occurs continuously.

Given the peculiarities of this kind of "quiet hunting", some prefer buying their own handmade donkey making on bream.

As a rule, in self-made gears, the bait spring is made of stainless steel wire, better steel, with a diameter of one millimeter. In a lead ball, two holes are drilled from the lead. One is for pressing the end of the spring, and the second is for the plastic tube, the ends of which, after assembly, are fused until the edges are obtained, and then threaded for strength.

The search for a place for fishing consists of two stages: preliminary and basic. To begin with, the water is monitored to detect the location of the fish, then the depth of the reservoir is determined by the depth gauge, and only then does the hunting begin.

In this case, there are several subtleties, to know which is necessary, so that the bream on the donka is caught continuously and does not slip off the hook. First, the rod must be positioned so that it is parallel to the shore line, and the angle between it and the line is relatively straight.

Secondly, in equipping donki, in no case can the sinker be replaced with a heavier feeder, since it can pull the empty spring from the lured track away from the wind or waves, and the hook with the nozzle will also go with it.