Pattern of a coat for a girl. How to sew a winter coat for a girl with her own hands?

The needlewomen know how much money can be saved if they sew children clothes themselves. Naturally, the products are obtained not worse than in the market, and sometimes even better quality with regard to tailoring and the materials themselves, requires some experience. But it's all about practice. Therefore, it's time to arm yourself with sewing supplies, fabrics, accessories and useful tips on how to sew outerwear, and get to work.

This article will discuss how to build a coat for a girl, the main stages of modeling at the stage of the template, as well as given advice on the choice of materials and their processing.

Stage one: taking measurements

To coat well sat on the figure of the child, it must be sewed in accordance with the features of the build. Individual tailoring is good and that measurements taken directly from a person are always used, and not generally accepted dimensional standards. The ideal coat pattern for a girl should be based on basic measures such as the width of the back, chest girth and girth of the abdomen or thighs (a greater value is taken). It is for these parameters that the planting of the product is usually evaluated. In the shoulders of the thing should not be too large, and on the tummy should be wide enough that under the coat without difficulty you could wear a warm sweater.

Of course, additional measures are required, such as breast height, sleeve length and length of the product, shoulder width.

Stage two: building the basis for the design of shelves

Patterns of a child's coat for a girl are built on the basis of a rectangle, where the horizontal side is equal to the girth of the chest + 5 or 7 cm for a free fit. Vertical sides must correspond to the length of the product.

Further, the whole process consists in transferring the measurements taken from the figure to paper:

• Determine the level of the line of the breast in accordance with the "breast height" measurement.
• Next, on this horizontal line, note half the measure "back width" + increase the free fit and put a point. After determine the size of the armhole. For this purpose, the chest girth is divided by 4 and the obtained value is deposited in the drawing from the previously set point.
• The remaining segment will be the zone of the front shelf.
• Below the line of the chest about 25-30 cm (the exact value can be measured from the chest and up to the bulging tummy or thighs), another horizontal line is laid on which ½ measures of greater girth (hips or abdomen) are deposited.
• Further in the zone of the armhole, find the middle and put a point from which the lateral seam will be lowered.
• On the line of the thighs or abdomen, lay on each vertical side of the rectangle by ½ measure of greater girth (hips or abdomen) + 5 or 7 cm for free fit. Afterwards, starting from the midpoint in the armhole area and to these marks, straight lines are lowered, which somewhat extend to the bottom of the article.
• Then again, go up to the upper side of the rectangle, lay off from the top corner of 5-6 cm for the neck, from the received point, set aside the "shoulder length" measure and deepen the neck opening by 1.5 cm for the backrest and for 5 cm for the front shelf. Shoulder stitches for the transfer are drawn similarly to the back.
• Next, go to the armhole, where you need to connect the extreme points of the shoulder seams with the previously set middle. At the same time, all sharp corners should be leveled. In order to correctly shape the armhole, auxiliary verticals will be required: from the point of width of the back to the top and from the point of the border of the armhole and the front shelf and up to the top.

Additional model details

Patterns of a child's coat for a girl do not have darts for the chest, which somewhat facilitates the construction. If you intend to sew a product with darts, additional measurements will be required, such as a dart solution, which is measured from the center to the center of the chest. Half of this measure is postponed on the drawing along the line of the chest from the front shelf, from the received point the perpendicular is lifted. On the shoulder line, retreat 3-5 cm to the edge of the shoulder and lower the line to the starting point. After the shoulder line is extended to the same distance and the armhole line is corrected. This pattern of coat for a teenage girl is suitable. If desired, the dart can be moved to the area of the armpit, cutting the paper piece until both lines of the vertical tuck are aligned to form a flat plane on the paper.

Stage Three: Building a Sleeve

The pattern of a child's coat for a girl (3 years old, more or less - is not important) can be with a one-piece sleeve. Such a pattern is constructed by the type of "bat", where the shoulder seams are extended to the required length and the lower seam of the sleeve is removed from the side cut, rounding the part in the area of the armpit. At such a cut, the bottom can be well flared or, conversely, narrowed, as in the coat-cocoon models.

To build a template vtachnoy sleeve, you need ready-made patterns of shelves. They are folded over the shoulder sections, a sheet of paper is placed on a sufficient size for the drawing and a solid armhole is drawn around the joint. The upper pellet resembles a circle, which must be finished and closed. After the joint at the junction point, the line is lifted by 1 cm. Further along the lower boundary of the circle, a horizontal line is drawn, and, dropping along the circumference, the edges of the sleeve are no longer formed. In this case, it is necessary to take into account the length of the armhole armhole so that the arm enters without problems.

Stage four: modeling

When a patterned coat pattern for a girl is ready, it's time to try your hand at the role of designer and designate the model lines. It can be pockets, zippers, inserts, embroidered seams, embroideries, decorative frills and so on. To make it easier to submit the final version, it is better to draw a sketch of the product. This will help to determine both the size of the flapping of the shelves down, and the length of the sleeve with its model features. The sleeve can be decorated with a bow or make three quarters, supplementing it with a high dovetail.

Material selection

There are so many choices in fabric stores that it's sometimes difficult to decide which fabric to give preference to. Here we should proceed not only from the style of the product, but also from the use of outerwear. Whether it's demi-season, or winter outerwear. The pattern of a coat for a girl, described above, is suitable for both variants, but the differences can be in the allowances for a loose fit, a heater and, of course, the main canvas used. It can be plashevka, cashmere, polor or other coats.

As a heater you can choose holofayber, sintepon or sintepuh. For interior finishing, it is better to take a dense lining fabric and separately "figure out" the podstezhku on the sheepskin. This will allow to put on a thing both at plus temperature, and in decent frost.

Sew lightly

The manufacturing process is not so complicated in fact, so we postpone all doubts and sew a winter coat! The pattern of a coat for a girl is also constructed easily enough, a bit of zeal - and it will work out! A little imagination for decoration, a few strokes in the form of relief seams or stitching - and there will be a great product. A ready-made pattern of a coat for a girl can be used for sewing a summer cardigan and for a windbreaker. A little adjust the length and think over additional details in the form of a collar-stand, hood and cuffs - and a whole collection of children's clothes is ready!