Optimizing the Windows XP paging file

The paging file is a hidden file on a hard drive of computers or laptops. To understand what a swap file is for, you need to know that it is used by the operating system in the same way as the RAM. For example, if you run a large number of tasks and the amount of RAM is not enough, then the paging file comes to the rescue.

The physical memory of the computer in tandem with this file form a virtual memory. When you install the operating system on your computer, the Windows XP paging file is automatically created and located in the root directory on the hard drive where the system and system files are located. Usually the size of this file corresponds to the amount of RAM installed on the computer. Although now it is not necessary, because the amount of RAM became much larger than it was before.

Many people often ask themselves if a paging file is needed at all. The answer is clear-need. After all, in case of unforeseen disruptions, thanks to the swap file, it is possible to restore the operating system. Let's see what the process of configuring this file is.

In order for the system to work faster, you first need to move the Windows XP paging file to another hard drive. This will allow the system to process I / O requests much faster, which are repeated all the time. After all, while it is in the download section, Windows sends read requests from the disk and writes to it as a swap file, and to the system folder. If this file is on another disk, then the competition in the requests for writing and writing will be significantly reduced.

But if the Windows XP paging file is missing from the boot sector, then there may be negative consequences. Windows will not be able to create a file for emergency copying of memory and for saving information for recovery if a fatal error occurs in kernel mode. This can lead to a long downtime of the system.

In order for this to happen there is an optimal solution. You need to create one swap file in the boot partition, and the second instance must be created in the section that is not used so often, i.e. On another hard drive, if such a course is available. Ideally, there will be a separate partition where there are no data and system files. Then the operating system will first use the swap file from there, and not from the boot partition to which the system is constantly referring. For such a definition, a special algorithm will be used.

More about The bottom of the dignity when using a separate section for this file is that the latter is not fragmented, unlike the case with its being in the boot partition. After all, as a result of constant changes in its size in the boot partition, it starts to break into parts, which leads to a significant increase in the time for its processing by the system.

Having completed all the above tips and recommendations, you will create the necessary conditions for speeding up, optimizing and recovering the operating system.

For the most part, the Windows XP swap file will be used, which is located in the less loaded section. And the system itself will be set up properly to write the Memory.dmp file if a kernel mode error occurs.