How to make an anchor for a PVC boat with your own hands? Instructions for the fisherman

Fishing, of course - a favorite occupation of the average male citizen. And to retire, swim away from everyone - so this is the most cherished desire of many fishermen. At the same time, the anchor for a PVC boat is one of the most necessary devices for fishing on the water, because your "boat" is not torn down by the current (on the river) or by the wind (on a lake or pond), you need to fix it properly!

What is a PVC boat (brief reference)

This abbreviation is correctly deciphered as polyvinyl chloride. The most important quality - PVC does not support burning, unlike, for example, ordinary rubber. This material was invented in the nineteenth century. Then, forty years later, his industrial production was organized. PVC is used for the production of children's toys, buildings, awnings and, of course, boats! For fishing, a special reinforced boat material is used, which is much heavier than usual. So, a boat with a length of two meters should weigh not less than 10 kg, otherwise it is a simple inflatable mattress with oars and seats, unsuitable for long swimming and fighting with the elements! Typically, eleven-layer PVC is used, but there may be more layers. Not the most recent role for the quality of the canvas is its density. The denser the longer the ship can be made. Choosing the most qualitative boat, the fisherman will maximally protect both himself and the people who are with him on fishing. And still, choosing a boat made of PVC, you need to pay attention to the tensile strength (tensile strength) to know for sure the carrying capacity of your vessel.

How to make an anchor for a PVC boat with your own hands?

Such a necessary adaptation can, of course, be bought at any large fishing store. But you can try to make an anchor for a PVC boat by yourself - and cheaper, and you will always be sure of the reliability of this "work of fishing art". There are several time-tested and human options, which are listed below.

Kurbatov - welded, self-made

An anchor for a PVC boat can be made by hand using a wire with a diameter of at least eight millimeters, a sheet steel of three millimeters in thickness and a piece of a metal rod with a diameter of twelve millimeters. The design has only one paw and a small bifurcated spindle, weighs just over two kilograms and is compact. Can be used on boats up to five meters long. So, the step-by-step instruction "How to make an anchor for a PVC boat with your own hands".

1. We twist the spindle from the wire. In its upper part we weld the bar.

2. We weld the washers and the straps (fixing) to the rod, which, when the structure hits the bottom, unfolds the paw and forces it to cling to the ground.

3. At the rod ends of the spindle are welded by a strip of metal, which supports the paw in the working position.

4. This anchor holds well on many soils, but if the bottom is rocky, it is necessary to have a removable stick weighing up to four kg, which can be easily put on the end of the anchor and lowered with it.

In recent years, the factory anchor "Trident" has been used abroad, which differs little in design from Kurbatov. His paw is wider and made in the form of a trident. He also holds the boat well on loose ground, biting into the soil. On a stony one, it is necessary to use ballast.

Foldable "cat"

Anchors-cats are quite reliable designs for small boats (three to four meters long). Their only inconvenience is storage on the ship. This anchor for a PVC boat with its own hands is easy to make, making it foldable. The whole secret is that all four paws of the structure will be pivoted to the bottom of the base. And the clutch, which slides on the spindle itself, stops in the upper, then in the lower position, fixing the legs of the anchor cat in the working or folded along the spindle state.