How to make a shower in the bath with your own hands?

The bath is associated with a hot thermae and fragrant brooms. But the shower under these conditions does not always seem appropriate, but modern people can not do without it. It will be much more pleasant to stand under the warm streams of the shower than to splash with buckets and basins. Before and after the steam room, ice rain can replace an ice hole or a font. In this regard, many owners of suburban real estate and private houses in the city are wondering how to make a shower in the bath.

Options for the arrangement

Some house masters believe that there will be enough cold shower for the sauna, which will provide contrasting procedures. To bring hot water to it, as some believe, are excess. In this case, you can do without complex manipulations by installing a bucket-waterfall.

This device is usually located above the door, and with the help of a special mechanism the bucket can be knocked over. To fill it you will have to install a crane. Building a new bath, you should provide a separate shower room, where you can enter from the waiting room.

An alternative solution is to select the corner in the washroom. In the existing bath for these purposes, you can allocate space, the dimensions of which will be equal to 1.2 x 1.5 m. You can attach a shower room with an entrance from the waiting room. Some home masters even set up a shower cabin with hydromassage and other pleasures. However, it can not always be entered into the appearance of the wooden interior of a traditional bath.

How to apply water

If you have wondered about how to make a shower in a bath, then you should take care of the water supply. When the central water supply is supplied to the dacha or there is individual water supply from the well or well, it is only necessary to stretch the branch of the pipes to the bathhouse, providing for the heating of the shower water. If the sauna is heated exclusively by the oven, and you are sure that the shower and hot water for the bath are incompatible, then to provide pressure, you can install a storage tank on the roof or under the ceiling. In this case, the shower is located next to the furnace.

If the pressure is too low or the water is supplied from the well, it is necessary to take care of the pump for the head. He can be:

• Deep;
• Submersible;
• Superficial.

The first variety is capable of supplying water from an impressive depth. This solution is suitable for a well with a small diameter. Submersible pumps can be used to supply water from shallow sources such as streams, rivers, reservoirs and lakes. Surface pumps are capable of supplying water from 7 m.

In addition to the selection of pumping equipment

Before you make a shower in the bath with your own hands, you must take care of what equipment will be used to supply water. Calculation of the power of such devices should be entrusted to a professional. Selection of equipment is carried out depending on the type of water source.

It is important to consider also the depth of the source, as well as the loss of pressure. Surface pumps are convenient for their mobility. If desired, they can be transferred to another source of water by disconnecting the hose. Preferably the model with a float switch. In this case, the equipment will be automatically turned off: if the water level decreases, this will not allow the device to burn out. To compensate for power losses, suction units are sometimes supplemented with injectors, which allow maintaining optimal water circulation.

Owners of wells also sometimes wonder about how to make a shower in the bath with their own hands. Such consumers should choose a well pump, which is used for deep wells. For the latter suited submersible pumps, which are cheaper than borehole pumps, but have outstanding technical characteristics.

Method of heating water

If you are faced with the question of how to make a hot shower in the bath, then you must worry about the method of heating. This possibility will depend on whether the house is connected to a gas distribution network or power lines. In extreme cases, you can use your own electricity from the generator. Drawing a conclusion, we can say that among the ways of heating water there are the following:

• gas;
• Furnace;
• electric.

In the absence of sources of thermal energy, the old method of heating water - stove - is often used. To do this, install a tank, which can be built-in or remote. In it, the water is heated from the combustible firewood and distributed to the washing sector, as well as the storage capacity of the shower room.

Advantageous solutions

Before you take a shower in the bath, the photo should be considered. Perhaps they will allow you to understand which decision is better to give preference. If the dacha is connected to a centralized gas supply system, a gas water heater can be used to heat the water, which is represented by a gas column. It will heat running water, with the help of which it will be possible to prepare water for future use. In this case, it will be pumped into the storage tank.

An alternative solution is electrical heating. It is represented by inexpensive and convenient water heaters, which can be cumulative or flowing. Accumulating tanks do not have running water heaters. They are heated by a stream of water, passing through the heating elements.

How to choose a pipe

Before you make a shower in a wooden bath, you should choose pipes for it. For this system, the same products are used that are used for water supply and heating, among them:

• Metal-plastic;
• Copper;
• Polypropylene.

Taking into account the prices for copper pipes and the features of their installation, the popularity of polypropylene and metal-plastic products is much higher. They are cheaper, and the installation is very simple, so you do not have to invite specialists. Choosing metal-plastic pipes, you will not be disappointed, because they are not afraid of corrosion, they are flexible, plastic and easy to install, like polymer products. Among other things, the metal-plastic is durable and durable.

How to make a drain

Quite often, home masters are wondering how to make a shower in a bath, the installation of such a system can be carried out by yourself. To do this, it is important to study what technology to use for drainage. When designing the system, you must provide for a concreted pit. It will receive used water, which goes through the trappings. Then the sewage will be removed to the pit outside the building.

The same route is also used for sewage from the shower. In the floor for this, it is necessary to equip the corresponding trapezik, connecting it with the pipe of the collecting pit. Some build a drainage system from the shower into the sewage system of the house. If you use a cesspool, then it will be filled with this approach quite quickly, the suction car will have to be invited more often.

Shower from heat exchanger

If you, too, were among those who thought about how to make a shower in a bath from a heat exchanger, you can save on electricity. As a basis of such a system will act as a sauna stove. It should be installed a water tank. It can be located in another room. On sale today you can find stoves that allow the use of thermal energy from the burning of firewood to heat water. These devices are furnaces with a tank, which is located on top.

The heat exchanger is used for heating cold water, as well as for storage in a remote tank. If you compare the heaters with a heat exchanger and equipment with a built-in tank, then the first can say that they allow you to use water to feed to different points of water intake. It can be not only a shower, but a kitchen sink.

If you are faced with the question of how to make a shower in the sauna from a stove with a heat exchanger, then you should become more familiar with the principle of the operation of such a system. It consists in the fact that cold water enters the heat exchanger and heats up, and then, under the influence of increased pressure, enters the storage tank, which is located at the top of the system. After a while, the water in the tank is heated to the desired temperature, and when using the water intake point, water under the influence of internal pressure comes to the shower mixer.

If the sauna stove is heated, the water will heat up and enter the combined heat exchanger. Here the heat is transferred to cold water. It will circulate in a closed loop, and the temperature will be maintained at a constant level during the operation of the water intake point. This system is universal, it allows you to use a bath oven or electric water heater to heat water. They can work simultaneously.

If you have wondered about how to make a shower in a bath from a tank, you have to remember that the water will only heat up from the stove heat exchanger, whereas the combined water heater will become an ordinary storage tank. In doing so, it must be disconnected from electricity. In this case, the principle can work the other way round: if the stove is not heated, the heat exchanger will act as an electric water heater. For forced heating, you can connect both heat exchangers. The electric power consumption will be less, in comparison with a conventional electric boiler, because in order to achieve the goal, a bath oven will also be used.

Budget variant of the shower room

If you have a question about how to make a shower in the bath, then you can use the budget option for its device. At the first stage, an annular foundation is laid for this, on which pipes are laid on top, their diameter should be 5 cm. The number of products is three.

The next layer will be corrugated board, on it there is a plastic pipe for a warm floor. In the central part, you should make a hole in a square shape with a side of 20 cm. It will also require a pit of 0.5 m. In this case, the water will go to the ground itself, and the structure should be poured with concrete, after which the tiles are laid after hardening. In the floor, there must be a pipe for ventilation, and the usual sewer, which is 10 cm in diameter, is also suitable. It is led out onto the street through a wall.

Shower room finish

At the next stage, plastic panels are installed, the width of which is 20 cm. But the lining for such a room is unsuitable. Panels are mounted on the crate from the metal profile with the help of self-tapping screws. Everything must be well waterproofed, so that even a drop of water does not leak out by accident. Now the pipe from the floor is connected to the heating in the bath, the next step is to start installing the shower.

On the features of installing a flow-through water heater for the shower

If you decide how to make a shower in a sauna in the country, then you can choose a flow-through water heater, which has a compact size, so it does not take much space. Such equipment is preferable if you have the opportunity to receive electricity stably, without jumps and drops.

The network cable should be purchased separately, usually it is not included in the delivery. For this, a three-core copper wire is used, the cross section of which is 2.5 mm ² . The socket should be designed for 16 A, it must have a grounding and a separate automatic device.

Recommendations of a specialist

From the back of the housing, an electric wire is connected via a terminal. The body is mounted on a vertical surface using fasteners. It is important to ensure the correct position of the device in relation to the vertical and horizontal. If the heating coil or some part inside is above the water level, this will cause the equipment to fail.

The hose with the watering can be screwed to the outlet. To the inlet there is a hose from cold water. If you decide on how to make a shower in a bath, then it can be assumed that the manipulations on installing a flow heater have been completed.

Conclusion

A bath in a person's life plays a very important role. On the question of whether there is a shower there, lovers of the couple answer ambiguously. Everyone has his own reasons for this or that answer. If you answer in the affirmative, preferring to refresh yourself after bath procedures, you should think about what technology to implement the arrangement of the shower.