How to make a dog from a sausage ball? Councils of Skilful Masters

Did you know that the art of modeling figures and balloons has its name - "twisting"? This term originated from the English word twist, which means "twist, rotate". He appeared because of the manner of creating models - they are made by the method of twisting individual parts of a long ball.

Well and if to ask, what figure made by means of twisting, is the most popular at children and adults the answer will be, certainly, that it is a dog. And today we will learn how to create such a model on our own, good, it's quite simple. So, how to make a dog from a sausage ball?

A few important points

For starters, a few general tips. Twisting implies that the model will be created from one or more balls. They need to be inflated. However, this should not be done until the end. The tails of the balls should be left at half-mast, because when they twist they fill with repressed air.

What else should I remember before I make a dog from a sausage ball? All twists in twisting should be done in the same direction. Then there will be no risk that the figure will fall apart right in your hands. Well, also do not forget that you need to start work from the bottom of the ball, gradually moving to its tip. Such basic recommendations will allow you to quickly master the art of twisting.

We make

Well, the advice was distributed, and now is the time to learn how to make a dog from a ball. To do this, we need a pump, the so-called "SHDM", as well as a little patience and imagination. Under the abbreviation is the abbreviated name of the ball for modeling, also known as sausage. It must be inflated with a pump and securely fasten the base to the knot.

It should be done as carefully as possible, because it will play the role of our dog's nose. Now measure about a quarter of the ball and bend it. We press tightly to the main "trunk". The middle of the measured segment is twisted together with the corresponding part of the remaining ball together. So at us the muzzle turns out: a bottom of a short part with a knot-nose. But the upper two parts are the ears, which our dog raised from the balloon.

Feet and torso

Now let's take care of the front paws. Before you make a dog from a ball-sausage, you should roughly mark out how many centimeters to give to different parts of the body. And the front paws are no exception, they need not be made too long to leave a piece of the ball for the rear. From the head we measure a piece of neck, and then two equal segments under the paws. In a place where one ends and another begins, the ball needs to be bent in half and press the parts tightly against each other. At the point where our dog supposedly ends the neck, both paws and neck should be tightly twisted. Next, the ball will already move into the trunk.

In the rear part, similarly, we form two more paws and a tail. And in our master class, the most important thing is to draw a muzzle. Pick up a marker, draw eyes and optional mouth. And now the basics of twisting are mastered! We hope, now you understand how to make a dog from a ball-sausage.