Machine on the control panel for drift, or What is drift

Today, a drifting lover can breathe a sigh of relief. Now, you do not need to spend a lot of money to buy a racing car, because there is a car on the control panel for drift. And believe me, this is not only a toy for a child, it can interest any adult.

Model for drift

Managed skidding and sliding are very spectacular. They are able to gather around themselves quite a few fans. However, the drift machine on the control panel has many nuances. It should be near the edge of the track at an incredible angle and move with great speed to get ahead of the other race participants that follow it on the heels. This atmosphere captures not only the pilots, but also the public, who was going to see it.

Basic tricks of drift

- Slip, which is performed with the disruption of four wheels.

- A skid that is used to pass S-turns.

- Reception, when the machine on the control panel for drift brakes to enter into a turn, and then rushes forward at high speed.

- Lateral slip when the rear wheels break.

- Chokudori - the car brakes slip and is exposed at such an angle as it is necessary to pass the turn.

- Manji - swinging the car from side to side. Usually, this is done by drifting on machines on the control panel at demonstration performances.

During the drift, to enter the turn, you can completely squeeze the gas. You can press the trigger gently, but you need to make sure that the drift is fully controllable.

Customizing the model

Any machine on the control panel for drift can be configured. After all, you can slide on any model, the main thing is that it should be an all-wheel drive vehicle. Most often for this purpose, use a car with an electric motor, which is made in a scale of 1:10. It is this car that behaves like the present, and the battery pack can work more than half an hour. Today the machine on the control panel for drift is created by many manufacturers. Among them you can call HSP Flying Fish 1 and Tamiya TB-03D Drift Spec. As a rule, they differ from each other suspension, rubber, shock absorbers and various accessories.

Any car enthusiast can create his own model himself

1. For successful drift, you need to choose the right rubber. Here you will need hard tires (for a good slip on the road). For this purpose, you can use plastic bottles or PVC pipes.

2. In order for the front wheels to get as close to the road as possible and the rear wheels to be as small as possible, you need to adjust the suspension correctly. The degree of camber in the front should be -4, and in the back - 0.

3. Torque is very important in drifting. Therefore, to ensure that the motor does not overheat, and the wheels are easily turned, it is necessary that the ratio is at least 1: 7.

4. Driving should be practiced. It is worth first to travel on a flat section of the road, turning the steering wheel in different directions. It is necessary to learn to feel the moment when the wheels lose traction with the road. After that, you can practice at the corners.

Only after all the points have been mastered, you can begin to enter the machine into drift.