How to paint the machine yourself

How to paint the car? Most will say that you just need to go to the car service. But for a number of reasons, some drivers do not want to do this. They prefer to solve these problems on their own. Perhaps, there is simply no extra money, or they do not trust masters. After repainting a car is quite an expensive pleasure.

If you are interested in how to paint a car, you should know: this process, performed independently, differs from manipulations that are carried out by specialists. If you think that it is enough to pour auto paint and wait for drying, then you are very wrong. You will need to prepare, apply some technologies, use special tools and equipment. Only in this case you will understand how to paint the car yourself.

Where do I start? First of all, it is worth carefully washing the car. On a clean machine, you can easily consider all the defects in the bodywork. After all, during the movement, he and the "bottom" of the car "polished" with stones, grains of sand and other.

You will need to do the preparatory work. And the procedure of painting can be point, partial, capital. Everything depends on the body damage.

So, if you needed a capital car painting, you need to be patient. A lot of time will be spent preparing the machine for this procedure. You will need to remove the seals, locks, moldings - all this can interfere with the painting. Some prefer not to remove the above items, but simply glue them with a paint tape. It is not right. Under them will accumulate moisture, which can damage the machine in the future. Now you need to clean the car body, then it shpaklyuetsya and primed. Without this, you will not understand how to properly paint the car.

The old paintwork should be removed, and if there are foci of corrosion, they should be treated. If you consider the process of preparing a car for painting, then it has five stages:
1. Washing machine with shampoo to remove contaminants.
2. Body degreasing.
3. Elimination of corrosive foci, mandatory removal of old paint by abrasive grinding using grinding paper and silicon carbide with aluminum dioxide.
4. Primary and secondary priming, which allows you to create an anti-corrosion coating on the body.
5. Stage of application of enamel and varnish.

Now you can figure out how to paint the car. Select the material. If you are a fan of matte colors, buy single-layer simple colorful coverings. And for fans of shine and radiance in the sun, they produce coatings with the effect of mother-of-pearl or metallic.

You will need to apply three coats of paint. Do it by spraying. Some elements of the car will have to be protected from paint by gluing on them paper, adhesive tape, plaster.

It is necessary to dilute the paint so that its viscosity is optimal. At the initial procedure it is 26s. Four kilograms of soil is used for six kilograms of enamel, while the proportion of solvent in the composition should be 20 percent of the total. You will need a spray gun. There it is necessary to pour the composition, then apply the first layer.

For each composition, you need to use a separate spray gun or gun, for example, for paint, primer or putty.

You will need to choose a good spray gun, you can even adjust the airflow pressure, well, and of course the shape of the torch and the amount of liquid.
After drying the first layer, you can safely apply the second, and after him the third. In this case, the composition of the enamel is required different. Perhaps it is worth using more liquid paint.

If you know how to paint a car, the whole procedure will not take you more than two or three days. Observing all the requirements for technology, you can achieve a chic result. In any case, painting the car yourself is sometimes easier than paying huge amounts of money for it in a car workshop.