What is the control panel for ventilation?

In the ventilation system, even if it is small, some elements enter. In the event that certain sectors of the whole system, namely stubs, heaters, coolers, valves, etc., provide small sensors and connect a special control panel, the need for manual adjustment of the ventilation indicators is eliminated.

In order for the automatic control system to function more efficiently, microprocessor controllers are used as the basis for creating shields. Usually, those chips are used that can be programmed. Control panel with microprocessor controller is also capable of more complete data collection from sensors and their further analysis. The process of such collection is as follows: the controller compares the real parameters with those that were set, then the signal obtained as a result of the comparison is processed. After it, the control signal is sent to the execution devices.

The work of the communication system is conducted in several directions at once. The data is collected using special sensors, after which the analysis of all collected data produces a control panel, special communication equipment. Such a shield can be the form of a personal computer, laptop or mobile phone. With the help of these devices, the dispatcher always knows the characteristics of the system and those indicators that come from the microprocessor controllers. Usually the data is collected according to the following indicators:

1. Temperature level.

2. The qualitative composition of the air.

3. The level of pressure that operates in the air shaft.

4. The time when you need to replace all the necessary filters.

5. Level of emergency condition.

When certain signals are received, the dispatcher must immediately intervene. It is possible to suspend all work until the necessary measures are taken to solve the problem. This can only be done if a special module is installed in the ventilation control panel, through which communication with the operator's telephone or personal computer is made.

Communication means allow you to intervene remotely in the process of ventilation to further adjust and change the parameters that were set earlier. This function, which gives the operator a control board, although it sounds a bit fantastic, but has long been used in real practice.

Using programmable controllers with open protocols, you can remove all the differences between different devices. Such sensors allow the installation of control units that are assembled from different modules. Thus, it is possible to reduce the cost of the entire ventilation system as a whole, while not reducing the quality.

In addition, if you use a pump control board, you can reduce the cost of energy resources and equipment, which is necessary to protect the system from voltage surges and misuse.