How to install Wai-Fi at home?

The question of how to establish Wai-Fai does not arise for organizations and banks. For such purposes, a contract is concluded with specialized firms that solve this problem quickly and professionally. But when building a small home computer network, it is more than relevant. The services of a specialist of this profile are not cheap. Therefore, there is a desire to do this operation independently and at the expense of this, save money. Moreover, there is nothing complicated here, and even the novice user can do it.

Installation order

The algorithm for how to establish Wai-Fai is as follows:

• We establish connection of the router and other network components that are connected with each other by wires.
• Configuring the router.
• Create wireless network connections.

Connecting the router

The first stage in how to establish Wai-Fai is the establishment of all physical connections. The key element of the entire local area network is the router. It is with its commutation that it is necessary to begin this operation. On its back side, there are usually five ports for connecting a twisted pair and one round socket for power supply. Four ports are colored yellow, and one - in blue. At the last install the input wire from the provider. To the yellow jacks we connect all the devices that will be connected using a twisted pair. The other end of these wires should be installed in devices (televisions, receivers and system units, for example). Preliminary it is necessary to prepare all cable production. Next, connect the power supply to the router, and then install it in the socket.

Configuring the Router

The next important step in how to install Wai-Fai is to set the correct parameters for the router. To do this, we first connect it to a computer or laptop using a twisted pair. And the connection is only needed during the configuration phase. Then, if necessary, it can be removed. Turn on the router by pressing the power button on the back. Then we perform the same procedure with the system unit or laptop. After downloading each of them, proceed to the next step. Run any installed browser on the PC. In the address bar, type 192.168.1.1 and press enter. Next, you should see a prompt in which you must enter your login and password. This information can be specified on the router case or in the instruction manual. Then you need to configure the wireless router settings - its name, password for access and encryption method. The first two parameters can be chosen at your discretion. But the last one must be installed in WPA2 (this will allow you to get the maximum degree of network protection). Then the router reboots, after which it is ready to work.

Connecting a PC

At the final stage, you need to install Wai-Fi on your computer. It is most difficult to do this on a stationary system unit. You need to connect an external adapter to it using the USB interface. Next, install the driver on it from the CD that comes with the kit. In some cases, you may need to restart your PC. The next step is to start the adapter. It will list the available connections. In it, you need to select the one that was installed in the previous step. Then a window will appear in which you will be asked to enter a password. Then we wait until we get a network address - and we can start browsing the Internet. On laptops, this operation is much easier. The adapter with drivers in them is integrated and configured. Therefore, in this case, it all starts with a scan of the available connections. Further all is similar to adjustment of the stationary system block.

Conclusion

The article describes step by step the technique of how to set up a home-based Wai-Fi and configure it. Something super complicated does not exist in this operation, and it can be carried out even by a novice user. Therefore, we take it and do it boldly.