Bob kar with an extension - a hit of the season!

Before you cut the bean-curl with an elongation, it is worth considering that this hairstyle is most suitable for those girls who have a straight hair structure or, at least, wavy. It is undesirable to wear it to those girls who have curly and thick hair.

Required inventory: perfectly sharpened scissors, ordinary hairdresser's comb with small teeth, comb with a "tail", spray with warm water, clamps for fixation, hair clips.

Crochet with elongation, the scheme of a hairstyle

Before cutting, you should rinse your head well, using shampoo and balm. Now you can do Bob-kara with an extension. Using a comb "with a tail," you need to evenly divide the hair into two parts. Next, you need to make a horizontal parting from each side along the line of the ears. The resulting parts must be pricked with a pin and separate them so that they do not interfere with the cutting process. Only one lower part can be left undone.

Bob-kar with lengthening

With a simple comb from the very bottom of the strand, closer to the neck, it is necessary to disconnect horizontally a small strand about half a centimeter in diameter. Then - slowly hold this lock through your fingers to the bottom, trying to equalize it in your hand. Then you need to determine the desired length of the carat and cut from below as much hair as necessary to achieve it. By the same principle, it is worthwhile to divide and cut off the strand of the hair of the second lower part, after which it is again necessary to return to the first, select a strand of half a centimeter or a centimeter of hair and compare its length with the length of the hair whose strand has recently been cut off. All subsequent parts must be cut in such a way that they coincide and are the same length with the first cut. It is important to know that in order for the hair in this hairstyle to stand naturally and easily fit, cut the ends not at a right angle, but at an angle of 15 ° with respect to the previous strand.

Grooming the bean with elongation. Whiskey

After both parts have been cut to horizontal selection, you need to move to a responsible haircut of the temples. According to a similar technology should be separated strand, which is at the bottom. Do not forget also about moisturizing. The selected strand should be pulled towards the vertical parting. The length of the locks from the temple should be compared with the length of the temporal part. And, only by matching them well, it is necessary to cut off the ends of this strand. By the same principle, it is necessary to divide and cut off the upper strands of the temple. Once all parts of the hair have been sheared, you need to process the ends and check your hair. No matter how correctly and wisely hair has been cut, an ideal length can be achieved only after they are carefully aligned. Do not forget also that the temporal parts of the hair should be cut at the right degree in relation to the previous one.

Checking

Bob-kara with lengthening - this haircut Should be perfectly flat, that's why you need to dissolve the hair, comb them properly and begin to compare the length of each individual segment. In those cases where some parts, even if only slightly, but longer, they need to be trimmed. Stitch bob with elongation implies by itself that every hair in the square should be in its place, and not stand out, or, moreover, be short. The symmetry of the hairstyle is also very important. In order to check it, you need to take one temporal strand on both sides, pull them in front of the face and compare how they are the same. It is important that both these parts are the same length. In the event that they are something different, they need to be carefully adjusted. You can also check all the other strands of the temples. After the haircuts are finished, you can rinse the hair lightly again, thoroughly dry it and put the hairdo on.